[lkml]   [2022]   [May]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH] entry/kvm: Exit to user mode when TIF_NOTIFY_SIGNAL is set
On 5/4/22 12:08 PM, Seth Forshee wrote:
> A livepatch transition may stall indefinitely when a kvm vCPU is heavily
> loaded. To the host, the vCPU task is a user thread which is spending a
> very long time in the ioctl(KVM_RUN) syscall. During livepatch
> transition, set_notify_signal() will be called on such tasks to
> interrupt the syscall so that the task can be transitioned. This
> interrupts guest execution, but when xfer_to_guest_mode_work() sees that
> TIF_NOTIFY_SIGNAL is set but not TIF_SIGPENDING it concludes that an
> exit to user mode is unnecessary, and guest execution is resumed without
> transitioning the task for the livepatch.
> This handling of TIF_NOTIFY_SIGNAL is incorrect, as set_notify_signal()
> is expected to break tasks out of interruptible kernel loops and cause
> them to return to userspace. Change xfer_to_guest_mode_work() to handle
> TIF_NOTIFY_SIGNAL the same as TIF_SIGPENDING, signaling to the vCPU run
> loop that an exit to userpsace is needed. Any pending task_work will be
> run when get_signal() is called from exit_to_user_mode_loop(), so there
> is no longer any need to run task work from xfer_to_guest_mode_work().

Reviewed-by: Jens Axboe <>

Jens Axboe

 \ /
  Last update: 2022-05-05 02:38    [W:0.083 / U:2.932 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site