lkml.org 
[lkml]   [2022]   [May]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH 2/5] OPP: Make _generic_set_opp_regulator() a config_regulators() interface
    Date
    In order to reuse the same code path, i.e. clk_set_rate() from
    _set_opp(), migrate _generic_set_opp_regulator() to implement a
    config_regulators() interface.

    It is renamed to _opp_config_regulator_single() and is set as the
    preferred config_regulators() interface whenever we have a single
    regulator available.

    Note that this also drops code responsible for restoring the
    voltage/freq in case of errors. We aren't handling that properly
    currently, restoring only some of the resources while leaving others out
    (like bandwidth and required OPPs). It is better to drop all of it
    instead of partial restoration.

    Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org>
    ---
    drivers/opp/core.c | 51 +++++++++++-----------------------------------
    1 file changed, 12 insertions(+), 39 deletions(-)

    diff --git a/drivers/opp/core.c b/drivers/opp/core.c
    index bac91d078cbb..2f76442845be 100644
    --- a/drivers/opp/core.c
    +++ b/drivers/opp/core.c
    @@ -892,62 +892,34 @@ static inline int _generic_set_opp_clk_only(struct device *dev, struct clk *clk,
    return ret;
    }

    -static int _generic_set_opp_regulator(struct opp_table *opp_table,
    - struct device *dev,
    - struct dev_pm_opp *opp,
    - unsigned long freq,
    - int scaling_down)
    +static int _opp_config_regulator_single(struct device *dev, struct dev_pm_opp *old_opp,
    + struct dev_pm_opp *new_opp, struct regulator **regulators,
    + unsigned int count)
    {
    - struct regulator *reg = opp_table->regulators[0];
    - struct dev_pm_opp *old_opp = opp_table->current_opp;
    + struct regulator *reg = regulators[0];
    int ret;

    /* This function only supports single regulator per device */
    - if (WARN_ON(opp_table->regulator_count > 1)) {
    + if (WARN_ON(count > 1)) {
    dev_err(dev, "multiple regulators are not supported\n");
    return -EINVAL;
    }

    - /* Scaling up? Scale voltage before frequency */
    - if (!scaling_down) {
    - ret = _set_opp_voltage(dev, reg, opp->supplies);
    - if (ret)
    - goto restore_voltage;
    - }
    -
    - /* Change frequency */
    - ret = _generic_set_opp_clk_only(dev, opp_table->clk, freq);
    + ret = _set_opp_voltage(dev, reg, new_opp->supplies);
    if (ret)
    - goto restore_voltage;
    -
    - /* Scaling down? Scale voltage after frequency */
    - if (scaling_down) {
    - ret = _set_opp_voltage(dev, reg, opp->supplies);
    - if (ret)
    - goto restore_freq;
    - }
    + return ret;

    /*
    * Enable the regulator after setting its voltages, otherwise it breaks
    * some boot-enabled regulators.
    */
    - if (unlikely(!opp_table->enabled)) {
    + if (unlikely(!new_opp->opp_table->enabled)) {
    ret = regulator_enable(reg);
    if (ret < 0)
    dev_warn(dev, "Failed to enable regulator: %d", ret);
    }

    return 0;
    -
    -restore_freq:
    - if (_generic_set_opp_clk_only(dev, opp_table->clk, old_opp->rate))
    - dev_err(dev, "%s: failed to restore old-freq (%lu Hz)\n",
    - __func__, old_opp->rate);
    -restore_voltage:
    - /* This shouldn't harm even if the voltages weren't updated earlier */
    - _set_opp_voltage(dev, reg, old_opp->supplies);
    -
    - return ret;
    }

    static int _set_opp_bw(const struct opp_table *opp_table,
    @@ -1194,9 +1166,6 @@ static int _set_opp(struct device *dev, struct opp_table *opp_table,

    if (opp_table->set_opp) {
    ret = _set_opp_custom(opp_table, dev, opp, freq);
    - } else if (opp_table->regulators) {
    - ret = _generic_set_opp_regulator(opp_table, dev, opp, freq,
    - scaling_down);
    } else {
    /* Only frequency scaling */
    ret = _generic_set_opp_clk_only(dev, opp_table->clk, freq);
    @@ -2103,6 +2072,10 @@ static int _opp_set_regulators(struct opp_table *opp_table, struct device *dev,
    opp_table->set_opp_data->old_opp.supplies = supplies;
    opp_table->set_opp_data->new_opp.supplies = supplies + count;
    }
    +
    + /* Set generic config_regulators() for single regulators here */
    + if (count == 1)
    + opp_table->config_regulators = _opp_config_regulator_single;
    mutex_unlock(&opp_table->lock);

    return 0;
    --
    2.31.1.272.g89b43f80a514
    \
     
     \ /
      Last update: 2022-05-31 12:11    [W:2.616 / U:0.020 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site