Messages in this thread | | | From | Andy Shevchenko <> | Date | Mon, 30 May 2022 10:56:48 +0200 | Subject | Re: [RFC 2/2] iio: accel: bma400: Add support for single and double tap events |
| |
On Sun, May 29, 2022 at 6:02 AM Jagath Jog J <jagathjog1996@gmail.com> wrote: > > Add support for single and double tap events based on the tap threshold > value and minimum quite time value between the taps. INT1 pin is used to
quiet (see below as well)
The INT1
> interrupt and event is pushed to userspace.
an event
...
> +#define BMA400_TAP_QUITE_MSK GENMASK(3, 2)
QUIET ?
...
> + /* > + * No need to change ODR when tap event is enabled because > + * tap interrupt is operating with the data rate of 200Hz. > + * See datasheet page 124.
When referring to the datasheet, please be more specific, i.e. table / chart / section number and name, No page needed as it may be changed from version to version, also date of the document or revision would be nice to add.
> + */
-- With Best Regards, Andy Shevchenko
| |