lkml.org 
[lkml]   [2022]   [May]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [RESEND PATCH v5] PCI: Make sure the bus bridge powered on when scanning bus
From
在 2022/5/25 22:19, Bjorn Helgaas 写道:
> On Wed, May 25, 2022 at 01:27:21PM +0200, Rafael J. Wysocki wrote:
>> On Tue, May 24, 2022 at 10:58 PM Bjorn Helgaas <helgaas@kernel.org> wrote:
>>> On Tue, May 17, 2022 at 08:43:19PM +0800, Yicong Yang wrote:
>>>> When the bus bridge is runtime suspended, we'll fail to rescan
>>>> the devices through sysfs as we cannot access the configuration
>>>> space correctly when the bridge is in D3hot.
>>> Is the "D3hot" above a typo? I think devices are supposed to respond
>>> to config accesses when in D3hot. PCIe r6.0, sec 5.3.1.4.1:
>>>
>>> Configuration and Message requests are the only TLPs accepted by a
>>> Function in the D3Hot state. ...
>>>
>>> Functions that are in D3Hot are permitted to be transitioned by
>>> software (writing to their PMCSR PowerState field) to the D0active
>>> state or the D0uninitialized state. Functions that are in D3Hot must
>>> respond to Configuration Space accesses as long as power and clock
>>> are supplied so that they can be returned to D0 by software.
>> That applies to the device itself, though, and not to the bus under it.
>>
>> In general, a bridge in D3hot causes the bus segment on the other side
>> of it to be inaccessible even for config space accesses AFAICS.
> Oh, thank you! That was the piece I was missing. I'll tweak the
> commit log to say something like:
>
> A bridge in a non-D0 power state does not forward config accesses to
> its secondary side (PCIe r6.0, sec 5.3.1). Make sure the bridge is
> in D0 while we enumerate devices below it.

Thanks for the illustration and tweaking of this. I should have qualified
the "devices" in the commit with downstream or secondary to make it
less ambiguous.

>>>> It can be reproduced like:
>>>>
>>>> $ echo 1 > /sys/bus/pci/devices/0000:80:00.0/0000:81:00.1/remove
>>>> $ echo 1 > /sys/bus/pci/devices/0000:80:00.0/pci_bus/0000:81/rescan
>>>>
>>>> 0000:80:00.0 is a Root Port and it is runtime-suspended, so
>>>> 0000:81:00.1 is unreachable after a rescan.
>>>>
>>>> Power up the bridge when scanning the child bus and allow it to
>>>> suspend again by adding pm_runtime_get_sync()/pm_runtime_put()
>>>> in pci_scan_child_bus_extend().
>>>>
>>>> Cc: Rafael J. Wysocki <rafael@kernel.org>
>>>> Cc: Mika Westerberg <mika.westerberg@linux.intel.com>
>>>> Cc: Bjorn Helgaas <bhelgaas@google.com>
>>>> Signed-off-by: Yicong Yang <yangyicong@hisilicon.com>
>>>> Reviewed-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
>>>> ---
>>>> drivers/pci/probe.c | 12 ++++++++++++
>>>> 1 file changed, 12 insertions(+)
>>>>
>>>> diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c
>>>> index 17a969942d37..b108e72b6586 100644
>>>> --- a/drivers/pci/probe.c
>>>> +++ b/drivers/pci/probe.c
>>>> @@ -2859,11 +2859,20 @@ static unsigned int pci_scan_child_bus_extend(struct pci_bus *bus,
>>>> unsigned int used_buses, normal_bridges = 0, hotplug_bridges = 0;
>>>> unsigned int start = bus->busn_res.start;
>>>> unsigned int devfn, fn, cmax, max = start;
>>>> + struct pci_dev *bridge = bus->self;
>>>> struct pci_dev *dev;
>>>> int nr_devs;
>>>>
>>>> dev_dbg(&bus->dev, "scanning bus\n");
>>>>
>>>> + /*
>>>> + * Make sure the bus bridge is powered on, otherwise we may not be
>>>> + * able to scan the devices as we may fail to access the configuration
>>>> + * space of subordinates.
>>>> + */
>>>> + if (bridge)
>>>> + pm_runtime_get_sync(&bridge->dev);
>>>> +
>>>> /* Go find them, Rover! */
>>>> for (devfn = 0; devfn < 256; devfn += 8) {
>>>> nr_devs = pci_scan_slot(bus, devfn);
>>>> @@ -2976,6 +2985,9 @@ static unsigned int pci_scan_child_bus_extend(struct pci_bus *bus,
>>>> }
>>>> }
>>>>
>>>> + if (bridge)
>>>> + pm_runtime_put(&bridge->dev);
>>>> +
>>>> /*
>>>> * We've scanned the bus and so we know all about what's on
>>>> * the other side of any bridges that may be on this bus plus
>>>> --
>>>> 2.24.0
>>>>

\
 
 \ /
  Last update: 2022-05-25 17:54    [W:0.083 / U:0.148 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site