lkml.org 
[lkml]   [2022]   [May]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 38/40] hwmon: (lm90) Add support and detection of Philips/NXP NE1618
Date
NE1618 is similar to NE1617 but supports manufacturer and chip ID
registers as well as 11 bit external temperature resolution.

Signed-off-by: Guenter Roeck <linux@roeck-us.net>
---
Documentation/hwmon/lm90.rst | 10 +++++++-
drivers/hwmon/Kconfig | 2 +-
drivers/hwmon/lm90.c | 44 ++++++++++++++++++++++++++----------
3 files changed, 42 insertions(+), 14 deletions(-)

diff --git a/Documentation/hwmon/lm90.rst b/Documentation/hwmon/lm90.rst
index b2ca10f37218..ea1556be645c 100644
--- a/Documentation/hwmon/lm90.rst
+++ b/Documentation/hwmon/lm90.rst
@@ -411,6 +411,14 @@ Supported chips:

Datasheets: Publicly available at the Philips website

+ * Philips NE1618
+
+ Prefix: 'ne1618'
+
+ Addresses scanned: I2C 0x18 - 0x1a, 0x29 - 0x2b, 0x4c - 0x4e
+
+ Datasheets: Publicly available at the Philips website
+
* Genesys Logic GL523SM

Prefix: 'gl523sm'
@@ -469,7 +477,7 @@ ADM1020, ADM1021, GL523SM, MAX1617, NE1617, NE1617A, THMC10:
* 8 bit sensor resolution
* Low temperature limits

-NCT210:
+NCT210, NE1618:
* 11 bit sensor resolution for remote temperature sensor
* Low temperature limits

diff --git a/drivers/hwmon/Kconfig b/drivers/hwmon/Kconfig
index 494539e4be3d..981df62bd6ab 100644
--- a/drivers/hwmon/Kconfig
+++ b/drivers/hwmon/Kconfig
@@ -1367,7 +1367,7 @@ config SENSORS_LM90
MAX6696,
ON Semiconductor NCT1008, NCT210, NCT72, NCT214, NCT218,
Winbond/Nuvoton W83L771W/G/AWG/ASG,
- Philips SA56004, GMT G781, Texas Instruments TMP451 and TMP461
+ Philips NE1618, SA56004, GMT G781, Texas Instruments TMP451 and TMP461
sensor chips.

This driver can also be built as a module. If so, the module
diff --git a/drivers/hwmon/lm90.c b/drivers/hwmon/lm90.c
index de51d205b63f..77102e0a4440 100644
--- a/drivers/hwmon/lm90.c
+++ b/drivers/hwmon/lm90.c
@@ -87,6 +87,9 @@
* This driver also supports MAX1617 and various clones such as G767
* and NE1617. Such clones will be detected as MAX1617.
*
+ * This driver also supports NE1618 from Philips. It is similar to NE1617
+ * but supports 11 bit external temperature values.
+ *
* Since the LM90 was the first chipset supported by this driver, most
* comments will refer to this chipset, but are actually general and
* concern all supported chipsets, unless mentioned otherwise.
@@ -129,7 +132,7 @@ static const unsigned short normal_i2c[] = {
enum chips { adm1023, adm1032, adt7461, adt7461a, adt7481,
g781, lm84, lm90, lm99,
max1617, max6642, max6646, max6648, max6654, max6657, max6659, max6680, max6696,
- nct210, nct72, sa56004, tmp451, tmp461, w83l771,
+ nct210, nct72, ne1618, sa56004, tmp451, tmp461, w83l771,
};

/*
@@ -267,6 +270,7 @@ static const struct i2c_device_id lm90_id[] = {
{ "nct214", nct72 },
{ "nct218", nct72 },
{ "nct72", nct72 },
+ { "ne1618", ne1618 },
{ "w83l771", w83l771 },
{ "sa56004", sa56004 },
{ "thmc10", max1617 },
@@ -572,6 +576,13 @@ static const struct lm90_params lm90_params[] = {
.resolution = 11,
.max_convrate = 7,
},
+ [ne1618] = {
+ .flags = LM90_PAUSE_FOR_CONFIG | LM90_HAVE_BROKEN_ALERT
+ | LM90_HAVE_LOW | LM90_HAVE_CONVRATE | LM90_HAVE_REMOTE_EXT,
+ .alert_alarms = 0x7c,
+ .resolution = 11,
+ .max_convrate = 7,
+ },
[w83l771] = {
.flags = LM90_HAVE_OFFSET | LM90_HAVE_REM_LIMIT_EXT | LM90_HAVE_CRIT
| LM90_HAVE_ALARMS | LM90_HAVE_LOW | LM90_HAVE_CONVRATE
@@ -2149,20 +2160,29 @@ static const char *lm90_detect_nuvoton(struct i2c_client *client, int chip_id,
return name;
}

-static const char *lm90_detect_nxp(struct i2c_client *client, int chip_id,
- int config1, int convrate)
+static const char *lm90_detect_nxp(struct i2c_client *client, bool common_address,
+ int chip_id, int config1, int convrate)
{
- int config2 = i2c_smbus_read_byte_data(client, LM90_REG_CONFIG2);
int address = client->addr;
const char *name = NULL;
+ int config2;

- if (config2 < 0)
- return NULL;
-
- if (address >= 0x48 && address <= 0x4f && chip_id == 0x00 &&
- !(config1 & 0x2a) && !(config2 & 0xfe) && convrate <= 0x09)
- name = "sa56004";
-
+ switch (chip_id) {
+ case 0x00:
+ config2 = i2c_smbus_read_byte_data(client, LM90_REG_CONFIG2);
+ if (config2 < 0)
+ return NULL;
+ if (address >= 0x48 && address <= 0x4f &&
+ !(config1 & 0x2a) && !(config2 & 0xfe) && convrate <= 0x09)
+ name = "sa56004";
+ break;
+ case 0x80:
+ if (common_address && !(config1 & 0x3f) && convrate <= 0x07)
+ name = "ne1618";
+ break;
+ default:
+ break;
+ }
return name;
}

@@ -2335,7 +2355,7 @@ static int lm90_detect(struct i2c_client *client, struct i2c_board_info *info)
name = lm90_detect_nuvoton(client, chip_id, config1, convrate);
break;
case 0xa1: /* NXP Semiconductor/Philips */
- name = lm90_detect_nxp(client, chip_id, config1, convrate);
+ name = lm90_detect_nxp(client, common_address, chip_id, config1, convrate);
break;
case 0xff: /* MAX1617, G767, NE1617 */
if (common_address && chip_id == 0xff && convrate < 8)
--
2.35.1
\
 
 \ /
  Last update: 2022-05-25 16:02    [W:0.812 / U:0.176 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site