lkml.org 
[lkml]   [2022]   [May]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 15/17] ALSA: hda: cs35l41: Add defaulted values into dsp bypass config sequence
Date
From: Stefan Binding <sbinding@opensource.cirrus.com>

The config sequences for running with and without firmware and DSP
are different. The original behavior assumed that we would only
run without DSP only in the case where firmware load failed.
This meant the non-firmware sequence was written with the assumtion
that various registers would be set to their default value.
However, to support the ability to unload the firmware, the
non-firmware register sequence must be updated to update all
required registers, including values that would be defaulted,
in case the firmware sequence, which could have already run,
has changed their value.

Signed-off-by: Stefan Binding <sbinding@opensource.cirrus.com>
Signed-off-by: Vitaly Rodionov <vitalyr@opensource.cirrus.com>
---

Changes since v2:
- No change

sound/pci/hda/cs35l41_hda.c | 13 +++++++++++++
1 file changed, 13 insertions(+)

diff --git a/sound/pci/hda/cs35l41_hda.c b/sound/pci/hda/cs35l41_hda.c
index b4087d548646..8de956e6850c 100644
--- a/sound/pci/hda/cs35l41_hda.c
+++ b/sound/pci/hda/cs35l41_hda.c
@@ -35,11 +35,24 @@

static const struct reg_sequence cs35l41_hda_config[] = {
{ CS35L41_PLL_CLK_CTRL, 0x00000430 }, // 3072000Hz, BCLK Input, PLL_REFCLK_EN = 1
+ { CS35L41_DSP_CLK_CTRL, 0x00000003 }, // DSP CLK EN
{ CS35L41_GLOBAL_CLK_CTRL, 0x00000003 }, // GLOBAL_FS = 48 kHz
{ CS35L41_SP_ENABLES, 0x00010000 }, // ASP_RX1_EN = 1
{ CS35L41_SP_RATE_CTRL, 0x00000021 }, // ASP_BCLK_FREQ = 3.072 MHz
{ CS35L41_SP_FORMAT, 0x20200200 }, // 32 bits RX/TX slots, I2S, clk consumer
+ { CS35L41_SP_HIZ_CTRL, 0x00000002 }, // Hi-Z unused
+ { CS35L41_SP_TX_WL, 0x00000018 }, // 24 cycles/slot
+ { CS35L41_SP_RX_WL, 0x00000018 }, // 24 cycles/slot
{ CS35L41_DAC_PCM1_SRC, 0x00000008 }, // DACPCM1_SRC = ASPRX1
+ { CS35L41_ASP_TX1_SRC, 0x00000018 }, // ASPTX1 SRC = VMON
+ { CS35L41_ASP_TX2_SRC, 0x00000019 }, // ASPTX2 SRC = IMON
+ { CS35L41_ASP_TX3_SRC, 0x00000032 }, // ASPTX3 SRC = ERRVOL
+ { CS35L41_ASP_TX4_SRC, 0x00000033 }, // ASPTX4 SRC = CLASSH_TGT
+ { CS35L41_DSP1_RX1_SRC, 0x00000008 }, // DSP1RX1 SRC = ASPRX1
+ { CS35L41_DSP1_RX2_SRC, 0x00000009 }, // DSP1RX2 SRC = ASPRX2
+ { CS35L41_DSP1_RX3_SRC, 0x00000018 }, // DSP1RX3 SRC = VMON
+ { CS35L41_DSP1_RX4_SRC, 0x00000019 }, // DSP1RX4 SRC = IMON
+ { CS35L41_DSP1_RX5_SRC, 0x00000020 }, // DSP1RX5 SRC = ERRVOL
{ CS35L41_AMP_DIG_VOL_CTRL, 0x00000000 }, // AMP_VOL_PCM 0.0 dB
{ CS35L41_AMP_GAIN_CTRL, 0x00000084 }, // AMP_GAIN_PCM 4.5 dB
};
--
2.34.1
\
 
 \ /
  Last update: 2022-05-25 15:19    [W:0.206 / U:0.556 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site