lkml.org 
[lkml]   [2022]   [May]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH] kvm: x86/svm/nested: Cache PDPTEs for nested NPT in PAE paging mode
On Mon, May 16, 2022 at 2:06 PM Sean Christopherson <seanjc@google.com> wrote:
>
> On Fri, Apr 15, 2022, Lai Jiangshan wrote:
> > From: Lai Jiangshan <jiangshan.ljs@antgroup.com>
> >
> > When NPT enabled L1 is PAE paging, vcpu->arch.mmu->get_pdptrs() which
> > is nested_svm_get_tdp_pdptr() reads the guest NPT's PDPTE from memroy
> > unconditionally for each call.
> >
> > The guest PAE root page is not write-protected.
> >
> > The mmu->get_pdptrs() in FNAME(walk_addr_generic) might get different
> > values every time or it is different from the return value of
> > mmu->get_pdptrs() in mmu_alloc_shadow_roots().
> >
> > And it will cause FNAME(fetch) installs the spte in a wrong sp
> > or links a sp to a wrong parent since FNAME(gpte_changed) can't
> > check these kind of changes.
> >
> > Cache the PDPTEs and the problem is resolved. The guest is responsible
> > to info the host if its PAE root page is updated which will cause
> > nested vmexit and the host updates the cache when next nested run.
>
> Hmm, no, the guest is responsible for invalidating translations that can be
> cached in the TLB, but the guest is not responsible for a full reload of PDPTEs.
> Per the APM, the PDPTEs can be cached like regular PTEs:
>
> Under SVM, however, when the processor is in guest mode with PAE enabled, the
> guest PDPT entries are not cached or validated at this point, but instead are
> loaded and checked on demand in the normal course of address translation, just
> like page directory and page table entries. Any reserved bit violations ared
> etected at the point of use, and result in a page-fault (#PF) exception rather
> than a general-protection (#GP) exception.

This paragraph from the APM describes the behavior of CR3 loads while
in SVM guest-mode. But this patch is changing how KVM emulates SVM
host-mode (i.e. L1), right? It seems like AMD makes no guarantee
whether or not CR3 loads pre-load PDPTEs while in SVM host-mode.
(Although the APM does say that "modern processors" do not pre-load
PDPTEs.)

>
> So if L1 modifies a PDPTE from !PRESENT (or RESERVED) to PRESENT (and valid), then
> any active L2 vCPUs should recognize the new PDPTE without a nested VM-Exit because
> the old entry can't have been cached in the TLB.
>
> In practice, snapshotting at nested VMRUN would likely work, but architecturally
> it's wrong and could cause problems if L1+L2 are engange in paravirt shenanigans,
> e.g. async #PF comes to mind.
>
> I believe the correct way to fix this is to write-protect nNPT PDPTEs like all other
> shadow pages, which shouldn't be too awful to do as part of your series to route
> PDPTEs through kvm_mmu_get_page().

\
 
 \ /
  Last update: 2022-05-25 23:46    [W:0.469 / U:0.020 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site