[lkml]   [2022]   [May]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v2 2/2] HID: i2c-hid: elan: Add support for Elan eKTH6915 i2c-hid touchscreens
On Mon, May 23, 2022 at 02:23:24PM -0700, Douglas Anderson wrote:
> Like many i2c-hid touchscreen controllers, the Elan eKTH6915 has a
> reset GPIO hooked up to it. According to the datasheet, the way we're
> supposed to turn the touchscreen on is:
> 1. Turn on the 3.3V supply.
> 2. Turn on the IO supply. It's OK if this is hardwired to the 3.3V
> supply, but if it's not then it must be turned on _after_ the 3.3V
> supply.
> 3. Wait >= 1 ms.
> 4. Deassert the reset GPIO (reset GPIO is active low, so there would
> be a leakage path if this was deasserted _before_ the IO supply).
> 5. Wait 300 ms.
> Much of the above can be handled by the generic i2c-hid-of driver, but
> the "reset" GPIO is not supported by that driver. Thus we'll do the
> same as we did for Goodix and add a new tiny driver that uses the
> i2c-hid core.
> NOTE: support for this new touchscreen could theorically fit into the
> Goodix driver. I've made it a separate driver because the Elan driver
> supports _two_ regulators and it's unclear exactly how that would fit
> in with commit 18eeef46d359 ("HID: i2c-hid: goodix: Tie the reset line
> to true state of the regulator").
> Signed-off-by: Douglas Anderson <>
> Reviewed-by: Dmitry Torokhov <>

Reviewed-by: Matthias Kaehlcke <>

 \ /
  Last update: 2022-05-23 23:40    [W:0.083 / U:1.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site