Messages in this thread | | | Date | Fri, 20 May 2022 09:53:10 -0700 | From | Bjorn Andersson <> | Subject | Re: [PATCH v8 1/3] phy: qcom-edp: add regulator_set_load to edp phy |
| |
On Fri 20 May 09:26 PDT 2022, Kuogee Hsieh wrote:
> This patch add regulator_set_load() before enable regulator at > eDP phy driver. > > Signed-off-by: Kuogee Hsieh <quic_khsieh@quicinc.com> > --- > drivers/phy/qualcomm/phy-qcom-edp.c | 7 +++++++ > 1 file changed, 7 insertions(+) > > diff --git a/drivers/phy/qualcomm/phy-qcom-edp.c b/drivers/phy/qualcomm/phy-qcom-edp.c > index cacd32f..afd9e17 100644 > --- a/drivers/phy/qualcomm/phy-qcom-edp.c > +++ b/drivers/phy/qualcomm/phy-qcom-edp.c > @@ -87,12 +87,17 @@ struct qcom_edp { > > struct clk_bulk_data clks[2]; > struct regulator_bulk_data supplies[2]; > + int enable_load[2]; > }; > > static int qcom_edp_phy_init(struct phy *phy) > { > struct qcom_edp *edp = phy_get_drvdata(phy); > int ret; > + int i; > + > + for (i = 0; i < ARRAY_SIZE(edp->supplies); i++) > + regulator_set_load(edp->supplies[i].consumer, edp->enable_load[i]);
The regulator framework only accounts for the load of enabled regulator consumers, so you should be able to just call regulator_set_load() right after devm_regulator_bulk_get() and not carry the enable_load array of static constants.
Regards, Bjorn
> > ret = regulator_bulk_enable(ARRAY_SIZE(edp->supplies), edp->supplies); > if (ret) > @@ -635,6 +640,8 @@ static int qcom_edp_phy_probe(struct platform_device *pdev) > > edp->supplies[0].supply = "vdda-phy"; > edp->supplies[1].supply = "vdda-pll"; > + edp->enable_load[0] = 21800; /* load for 1.2 V vdda-phy supply */ > + edp->enable_load[1] = 36000; /* load for 0.9 V vdda-pll supply */ > ret = devm_regulator_bulk_get(dev, ARRAY_SIZE(edp->supplies), edp->supplies); > if (ret) > return ret; > -- > The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, > a Linux Foundation Collaborative Project >
| |