lkml.org 
[lkml]   [2022]   [May]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] arm64: dts: allwinner: h6: Enable CPU opp tables for OrangePi One Plus
From
Date
On 5/2/22 10:01 AM, Chukun Pan wrote:
> Enable CPU opp tables for OrangePi One Plus.
>
> This needs to change the CPU regulator max voltage to fit
> the OPP table.
>
> Also add the ramp-delay information to avoid any out of spec
> running as the regulator is slower at reaching the voltage
> requested compare to the PLL reaching the frequency.
>
> There is no such information for AXP805 but similar PMIC (AXP813)
> has a DVM (Dynamic Voltage scaling Management) ramp rate equal
> to 2500uV/us.

The AXP805 datasheet has this information in the description for REG 1A. DVM is
disabled by default, and when it is enabled, the default ramp rate is 10
mV/15.625 us == 640 uV/us.

Did you notice any instability without this delay?

> Signed-off-by: Chukun Pan <amadeus@jmu.edu.cn>
> ---
> arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi | 9 ++++++++-
> 1 file changed, 8 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi
> index 92745128fcfe..d7b82ef6be55 100644
> --- a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi
> +++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi.dtsi
> @@ -5,6 +5,7 @@
> /dts-v1/;
>
> #include "sun50i-h6.dtsi"
> +#include "sun50i-h6-cpu-opp.dtsi"
>
> #include <dt-bindings/gpio/gpio.h>
>
> @@ -64,6 +65,10 @@ reg_vcc5v: vcc5v {
> };
> };
>
> +&cpu0 {
> + cpu-supply = <&reg_dcdca>;
> +};
> +
> &de {
> status = "okay";
> };
> @@ -208,7 +213,8 @@ reg_cldo3: cldo3 {
> reg_dcdca: dcdca {
> regulator-always-on;
> regulator-min-microvolt = <810000>;
> - regulator-max-microvolt = <1080000>;
> + regulator-max-microvolt = <1160000>;
> + regulator-ramp-delay = <2500>;
> regulator-name = "vdd-cpu";
> };
>
> @@ -216,6 +222,7 @@ reg_dcdcc: dcdcc {
> regulator-enable-ramp-delay = <32000>;
> regulator-min-microvolt = <810000>;
> regulator-max-microvolt = <1080000>;
> + regulator-ramp-delay = <2500>;

This change is not related to CPU frequency scaling, so it belongs in a separate
patch (if it is needed).

Regards,
Samuel

> regulator-name = "vdd-gpu";
> };
>
>

\
 
 \ /
  Last update: 2022-05-03 04:27    [W:0.037 / U:0.312 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site