Messages in this thread | | | Date | Wed, 18 May 2022 18:00:50 +0200 | Subject | Re: [PATCH] ARM: configs: enable support for Kontron KSwitch D10 | From | Nicolas Ferre <> |
| |
Arnd, Michael,
On 18/05/2022 at 16:52, Arnd Bergmann wrote: > On Wed, May 18, 2022 at 3:15 PM Michael Walle <michael@walle.cc> wrote: >> >> The Kontron KSwitch D10 is based on a Microchip LAN9668 SoC. It is a >> managed ethernet network switch with either 8 copper ports or 6 copper >> ports and 2 SFP cages. >> >> Enable all required kconfig symbols, either as module where possible or >> compiled-in where it is not possible. >> >> Signed-off-by: Michael Walle <michael@walle.cc>
Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com>
>> --- >> FWIW, there will be a board in our lab in KernelCI using this config. > > The patch looks ok to me, but normally I'd expect it to go through the > platform maintainer tree unless there is a reason not to. Adding the at91 > maintainers to Cc here. > > It's also a bit late for 5.19, but if everyone agrees, I can add the patch > to the arm/late branch.
If it's possible for you Arnd, I do agree that you take it in the arm/late branch.
Thanks, best regards, Nicolas
-- Nicolas Ferre
| |