lkml.org 
[lkml]   [2022]   [May]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v3 1/6] dt-bindings: regulator: qcom,spmi-regulator: Convert to dtschema
From
On 18/05/2022 15:25, Robert Marko wrote:
>> I think we misunderstood each other. Old bindings indeed did not require
>> the interrupts, although if present they should be always defined.
>> Therefore here you should specify number of items and their names.
>
> Yeah, I think we are misunderstanding each other.
>
> Old text-based bindings specified the interrupts, but no naming or
> number was enforced,
> so I looked into the driver to see what is going on.
> Only pm8941 has interrupts defined in the driver and DTS, so I added
> those based on compatible
> matching, the same as with supplies.
> My logic was that it was only valid for interrupts to be described if
> PM8941 was used as describing
> interrupts for other regulator models will do nothing.

Indeed, you're right, thanks for explanation. Your patch in such case is
correct way of conversion but allows any number of interrupts with any
names, so it's to relaxed. Maybe then better go to previous version,
where these interrupts were defined only for one variant. For other
variants they would fail on as unevaluated?

Best regards,
Krzysztof

\
 
 \ /
  Last update: 2022-05-18 15:35    [W:0.649 / U:0.144 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site