lkml.org 
[lkml]   [2022]   [May]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] iio: vadc: Fix potential dereference of NULL pointer
On Tue, May 17, 2022 at 11:43:00PM -0700, Yongzhi Liu wrote:
> The return value of vadc_get_channel() needs to be checked
> to avoid use of NULL pointer, which is followed by
> the caller 'vadc_do_conversion' of function 'vadc_configure'.
> Fix this by adding the null pointer check on prop
> in function 'vadc_configure'.
>
> Signed-off-by: Yongzhi Liu <lyz_cs@pku.edu.cn>
> ---
> drivers/iio/adc/qcom-spmi-vadc.c | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/drivers/iio/adc/qcom-spmi-vadc.c b/drivers/iio/adc/qcom-spmi-vadc.c
> index 34202ba..d99bd72 100644
> --- a/drivers/iio/adc/qcom-spmi-vadc.c
> +++ b/drivers/iio/adc/qcom-spmi-vadc.c
> @@ -210,6 +210,9 @@ static int vadc_configure(struct vadc_priv *vadc,
> u8 decimation, mode_ctrl;
> int ret;
>
> + if (!prop)
> + return -ENODEV;
> +
> /* Mode selection */
> mode_ctrl = (VADC_OP_MODE_NORMAL << VADC_OP_MODE_SHIFT) |
> VADC_ADC_TRIM_EN | VADC_AMUX_TRIM_EN;


Shouldn't the check be done in vadc_measure_ref_points() where 'prop' is
obtained, rather than deep down in the call chain? For example
vadc_do_conversion() would also dereference the NULL pointer unless one
of the prior function calls fails.

\
 
 \ /
  Last update: 2022-05-18 19:32    [W:0.069 / U:0.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site