Messages in this thread Patch in this message | | | From | Max Krummenacher <> | Subject | [PATCH v1 04/17] ARM: dts: imx6q-apalis: Command pmic to standby for poweroff | Date | Mon, 16 May 2022 13:58:32 +0200 |
| |
From: Max Krummenacher <max.krummenacher@toradex.com>
The Apalis iMX6 HW doesn't allow to use the PWR_ON_REQ signal for poweroff. Use the fsl,pmic-stby-poweroff property to command the PMIC into a low power mode in poweroff.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com> ---
arch/arm/boot/dts/imx6qdl-apalis.dtsi | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/arch/arm/boot/dts/imx6qdl-apalis.dtsi b/arch/arm/boot/dts/imx6qdl-apalis.dtsi index e56451651a6d..668793356b46 100644 --- a/arch/arm/boot/dts/imx6qdl-apalis.dtsi +++ b/arch/arm/boot/dts/imx6qdl-apalis.dtsi @@ -125,6 +125,10 @@ status = "disabled"; }; +&clks { + fsl,pmic-stby-poweroff; +}; + /* Apalis SPI1 */ &ecspi1 { cs-gpios = <&gpio5 25 GPIO_ACTIVE_LOW>; @@ -387,6 +391,7 @@ pmic: pfuze100@8 { compatible = "fsl,pfuze100"; + fsl,pmic-stby-poweroff; reg = <0x08>; regulators { -- 2.20.1
| |