lkml.org 
[lkml]   [2022]   [May]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v6 4/4] thermal: k3_j72xx_bandgap: Add the bandgap driver support
From


On 10/05/22 22:47, J, KEERTHY wrote:
>
>
> On 5/10/2022 8:55 PM, Daniel Lezcano wrote:
>> On 09/05/2022 05:10, J, KEERTHY wrote:
>>>
>>>
>>> On 4/27/2022 12:16 PM, Keerthy wrote:
>>>> Add VTM thermal support. In the Voltage Thermal Management
>>>> Module(VTM), K3 J72XX supplies a voltage reference and a temperature
>>>> sensor feature that are gathered in the band gap voltage and
>>>> temperature sensor (VBGAPTS) module. The band gap provides current and
>>>> voltage reference for its internal circuits and other analog IP
>>>> blocks. The analog-to-digital converter (ADC) produces an output value
>>>> that is proportional to the silicon temperature.
>>>>
>>>> Currently reading temperatures only is supported.  There are no
>>>> active/passive cooling agent supported.
>>>>
>>>> J721e SoCs have errata i2128: https://www.ti.com/lit/pdf/sprz455
>>>>
>>>> The VTM Temperature Monitors (TEMPSENSORs) are trimmed during
>>>> production,
>>>> with the resulting values stored in software-readable registers.
>>>> Software
>>>> should use these  register values when translating the Temperature
>>>> Monitor output codes to temperature values.
>>>>
>>>> It has an involved workaround. Software needs to read the error
>>>> codes for
>>>> -40C, 30C, 125C from the efuse for each device & derive a new look
>>>> up table
>>>> for adc to temperature conversion. Involved calculating slopes &
>>>> constants
>>>> using 3 different straight line equations with adc refernce codes as
>>>> the
>>>> y-axis & error codes in the x-axis.
>>>>
>>>> -40C to 30C
>>>> 30C to 125C
>>>> 125C to 150C
>>>>
>>>> With the above 2 line equations we derive the full look-up table to
>>>> workaround the errata i2128 for j721e SoC.
>>>
>>> Hi Daniel,
>>>
>>> Any feedback on this series? Let me know.
>>
>> There are a few but that would be nit picking and I don't want to
>> postpone this driver any longer.
>>
>> How do you want to proceed? Shall I take it through my tree?
>
> Hi Daniel,
>
> Patch 1 & 4 i.e Documentation patch and driver patch can be picked by
> you. I believe Vignesh will take the dts patches.
>
> Vignesh,
>
> Can you confirm?
>

Yes, please decouple DT patches from driver+binding patches as they are
to be applied to different trees.


--
Regards
Vignesh

\
 
 \ /
  Last update: 2022-05-11 06:57    [W:0.083 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site