lkml.org 
[lkml]   [2022]   [May]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 7/9] i2c: npcm: Handle spurious interrupts
On Tue, May 10, 2022 at 05:16:52PM +0800, Tyrone Ting wrote:
> From: Tali Perry <tali.perry1@gmail.com>
>
> On some platforms in rare cases (1 to 100,000 transactions),
> the i2c gets a spurious interrupt which means that we enter an interrupt
> but in the interrupt handler we don't find any status bit that points to
> the reason we got this interrupt.
>
> This may be a case of a rare HW issue or signal integrity issue that is
> still under investigation.
>
> In order to overcome this we are doing the following:
> 1. Disable incoming interrupts in master mode only when slave mode is not
> enabled.
> 2. Clear end of busy (EOB) after every interrupt.
> 3. Clear other status bits (just in case since we found them cleared)
> 4. Return correct status during the interrupt that will finish the
> transaction.
>
> On next xmit transaction if the bus is still busy the master will issue a
> recovery process before issuing the new transaction.

...

> + /* clear status bits for spurious interrupts */

Clear

...

> + /*
> + * if irq is not one of the above, make sure EOB is disabled and all

If

> + * status bits are cleared.
> + */

...

> + /* verify no status bits are still set after bus is released */

Verify

...

> + /* check HW is OK: SDA and SCL should be high at this point. */

Check

...

> + if ((npcm_i2c_get_SDA(&bus->adap) == 0) ||
> + (npcm_i2c_get_SCL(&bus->adap) == 0)) {

This fits one line

> + dev_err(bus->dev, "I2C%d init fail: lines are low", bus->num);
> + dev_err(bus->dev, "SDA=%d SCL=%d", npcm_i2c_get_SDA(&bus->adap),
> + npcm_i2c_get_SCL(&bus->adap));

No '\n' at the end of each?!

> + return -ENXIO;
> + }

...

> + /* clear status bits for spurious interrupts */

Clear

...

> + /* after any xfer, successful or not, stall and EOB must be disabled */

After

...

Maybe you chose the small letter for one-liner comments, but I see even in the
original code the inconsistent style. Please, add an explanation to the cover
letter and follow it, assuming you add the patch at the end of the series that
makes comment style consistent (for the one-liners, for the multi-line comments
we have a clear understanding about the style).

--
With Best Regards,
Andy Shevchenko


\
 
 \ /
  Last update: 2022-05-10 12:15    [W:0.204 / U:0.528 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site