lkml.org 
[lkml]   [2022]   [Apr]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] dt-bindings: wkup-m3-ipc: Add ti,scale-data-fw property
Date
From: Dave Gerlach <d-gerlach@ti.com>

Add documentation for ti,scale-data-fw property to enable I2C PMIC
voltage scaling during deep sleep. The property contains the name of a
binary file for the CM3 firmware to load.

Based on previous work by Russ Dill.

Signed-off-by: Dave Gerlach <d-gerlach@ti.com>
Signed-off-by: Keerthy <j-keerthy@ti.com>
[dfustini: split from driver patch and convert to json-schema]
Signed-off-by: Drew Fustini <dfustini@baylibre.com>
---
.../devicetree/bindings/soc/ti/wkup-m3-ipc.yaml | 11 +++++++++++
1 file changed, 11 insertions(+)

diff --git a/Documentation/devicetree/bindings/soc/ti/wkup-m3-ipc.yaml b/Documentation/devicetree/bindings/soc/ti/wkup-m3-ipc.yaml
index 88d690de050c..d2c248d82384 100644
--- a/Documentation/devicetree/bindings/soc/ti/wkup-m3-ipc.yaml
+++ b/Documentation/devicetree/bindings/soc/ti/wkup-m3-ipc.yaml
@@ -40,6 +40,12 @@ description: |+
override the pin's existing bias (pull-up/pull-down) and value (high/low) when
IO isolation is active.

+ Support for I2C PMIC Voltage Scaling
+ ====================================
+ It is possible to pass the name of a binary file to load into the CM3 memory.
+ The binary data is the I2C sequences for the CM3 to send out to the PMIC
+ during low power mode entry.
+
properties:
compatible:
enum:
@@ -67,6 +73,11 @@ properties:
mbox_wkupm3 child node.
maxItems: 1

+ ti,scale-data-fw:
+ $ref: /schemas/types.yaml#/definitions/string
+ description:
+ Name of the firmware binary in /lib/firmware to copy to CM3 aux data
+
ti,vtt-gpio-pin:
$ref: /schemas/types.yaml#/definitions/uint32
description: GPIO pin connected to enable pin on VTT regulator
--
2.32.0
\
 
 \ /
  Last update: 2022-04-25 07:33    [W:0.072 / U:0.332 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site