lkml.org 
[lkml]   [2022]   [Apr]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH V4 15/31] x86/sgx: Support restricting of enclave page permissions
From
Hi Jarkko,

On 4/14/2022 4:19 AM, Jarkko Sakkinen wrote:
> On Thu, 2022-04-14 at 14:19 +0300, Jarkko Sakkinen wrote:
>> On Wed, 2022-04-13 at 14:10 -0700, Reinette Chatre wrote:
>>> In the initial (SGX1) version of SGX, pages in an enclave need to be
>>> created with permissions that support all usages of the pages, from the
>>> time the enclave is initialized until it is unloaded. For example,
>>> pages used by a JIT compiler or when code needs to otherwise be
>>> relocated need to always have RWX permissions.
>>>
>>> SGX2 includes a new function ENCLS[EMODPR] that is run from the kernel
>>> and can be used to restrict the EPCM permissions of regular enclave
>>> pages within an initialized enclave.
>>>
>>> Introduce ioctl() SGX_IOC_ENCLAVE_RESTRICT_PERMISSIONS to support
>>> restricting EPCM permissions. With this ioctl() the user specifies
>>> a page range and the EPCM permissions to be applied to all pages in
>>> the provided range. ENCLS[EMODPR] is run to restrict the EPCM
>>> permissions followed by the ENCLS[ETRACK] flow that will ensure
>>> no cached linear-to-physical address mappings to the changed
>>> pages remain.
>>>
>>> It is possible for the permission change request to fail on any
>>> page within the provided range, either with an error encountered
>>> by the kernel or by the SGX hardware while running
>>> ENCLS[EMODPR]. To support partial success the ioctl() returns an
>>> error code based on failures encountered by the kernel as well
>>> as two result output parameters: one for the number of pages
>>> that were successfully changed and one for the SGX return code.
>>>
>>> The page table entry permissions are not impacted by the EPCM
>>> permission changes. VMAs and PTEs will continue to allow the
>>> maximum vetted permissions determined at the time the pages
>>> are added to the enclave. The SGX error code in a page fault
>>> will indicate if it was an EPCM permission check that prevented
>>> an access attempt.
>>>
>>> No checking is done to ensure that the permissions are actually
>>> being restricted. This is because the enclave may have relaxed
>>> the EPCM permissions from within the enclave without the kernel
>>> knowing. An attempt to relax permissions using this call will
>>> be ignored by the hardware.
>>>
>>> Signed-off-by: Reinette Chatre <reinette.chatre@intel.com>
>>
>> Reviewed-by: Jarkko Sakkinen <jarkko@kernel.org>
>
> Also for this:
>
> Tested-by: Jarkko Sakkinen <jarkko@kernel.org>
>

Thank you very much.

Reinette

\
 
 \ /
  Last update: 2022-04-14 18:59    [W:0.102 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site