lkml.org 
[lkml]   [2022]   [Apr]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v4] PCI: qcom: Add system PM support
On Wed, 13 Apr 2022 at 08:49, Manivannan Sadhasivam
<manivannan.sadhasivam@linaro.org> wrote:
>
> On Tue, Apr 12, 2022 at 01:40:08PM +0300, Kalle Valo wrote:
> > + ath11k
> >
> > Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> writes:
> >
> > > +Kalle, linux-wireless
> > >
> > > On Tue, Mar 08, 2022 at 12:25:06AM +0530, Prasad Malisetty wrote:
> > >> Add suspend_noirq and resume_noirq callbacks to handle
> > >> system suspend and resume in dwc PCIe controller driver.
> > >>
> > >> When system suspends, send PME turnoff message to enter
> > >> link into L2 state. Along with powerdown the PHY, disable
> > >> pipe clock, switch gcc_pcie_1_pipe_clk_src to XO if mux is
> > >> supported and disable the pcie clocks, regulators.
> > >>
> > >
> > > Kalle, is this behaviour appropriate for WLAN devices as well? The devices
> > > will be put into poweroff state (assuming no Vaux provided in D3cold) during
> > > system suspend.
> >
> > ath11k leaves the firmware running during suspend. I don't fully
> > understand what the patch is doing, but if it cuts the power from the
> > WLAN chip during suspend that will break ath11k.
> >
>
> Thanks Kalle for the confirmation. Yes the device will be put into D3cold state
> and that will most likely equal to poweroff state.

Just to remind that ath11k on Qualcomm boards has a separate power
supply, not directly tied to the PCIe power supply.

> Prasad, you should try to just turn off the host resources like clocks and
> regulators (not refclk) and let the device be in the default state
> (D3hot/L{0/1}?) during suspend.


--
With best wishes
Dmitry

\
 
 \ /
  Last update: 2022-04-13 08:37    [W:0.065 / U:0.512 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site