lkml.org 
[lkml]   [2022]   [Apr]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH V2 13/15] cpufreq: mediatek: Link CCI device to CPU
Date
Rex-BC Chen <rex-bc.chen@mediatek.com> writes:

> On Fri, 2022-04-08 at 13:54 -0700, Kevin Hilman wrote:
>> Rex-BC Chen <rex-bc.chen@mediatek.com> writes:
>>
>> > From: Jia-Wei Chang <jia-wei.chang@mediatek.com>
>> >
>> > In some MediaTek SoCs, like MT8183, CPU and CCI share the same
>> > power
>> > supplies. Cpufreq needs to check if CCI devfreq exists and wait
>> > until
>> > CCI devfreq ready before scaling frequency.
>> >
>> > - Add is_ccifreq_ready() to link CCI device to CPI, and CPU will
>> > start
>> > DVFS when CCI is ready.
>> > - Add platform data for MT8183.
>> >
>> > Signed-off-by: Jia-Wei Chang <jia-wei.chang@mediatek.com>
>>
>> The checks here are not enough, and will lead to unexpected behavior.
>> IIUC, before doing DVFS, you're checking:
>>
>> 1) if the "cci" DT node is present and
>> 2) if the driver for that device is bound
>>
>> If both those conditions are not met, you don't actually fail, you
>> just
>> silently do nothing in ->set_target(). As Angelo pointed out also,
>> this
>> is not a good idea, and will be rather confusing to users.
>>
>> The same thing would happen if the cci DT node was present, but the
>> CCI
>> devfreq driver was disabled. Silent failure would also be quite
>> unexpected behavior. Similarily, if the cci DT node is not present
>> at
>> all (like it is in current upstream DT), this CPUfreq driver will
>> silently do nothing. Not good.
>>
>> So, this patch needs to handle several scenarios:
>>
>> 1) CCI DT node not present
>>
>> In this case, the driver should still operate normally. With no CCI
>> node, or driver there's no conflict.
>>
>> 2) CCI DT present/enabled but not yet bound
>>
>> In this case, you could return -EAGAIN as suggested by Angelo, or
>> maybe
>> better, it should do a deferred probe.
>>
>> 3) CCI DT present, but driver disabled
>>
>> This case is similar to (1), this driver should continue to work.
>>
>> Kevin
>
> Hello Kevin and Angelo,
>
> In my review, if we do not get the link or the link status is not
> correct between cci and cpufreq in target_index, I think it will never
> established again for this link.
> Because it's not checked in probe stage.
>
> So I think we just need to deal with the issue without cci device, and
> don't expect the link between cci and cpufreq will be connected again.
>
> If I am wrong, please correct me.

I don't fully understand your questions, but I think what your getting
at suggest that you might need to use deferred probe to handle the case
where the ordering of CCI and cpufreq probing is not predictable.

Kevin

\
 
 \ /
  Last update: 2022-04-11 20:14    [W:0.102 / U:0.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site