lkml.org 
[lkml]   [2022]   [Mar]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v6 8/8] drm/msm/dp: Handle eDP mode_valid differently from dp
Hi,

On Wed, Mar 30, 2022 at 11:02 PM Sankeerth Billakanti (QUIC)
<quic_sbillaka@quicinc.com> wrote:
>
> Hi Dmitry,
>
> > On Wed, 30 Mar 2022 at 19:04, Sankeerth Billakanti
> > <quic_sbillaka@quicinc.com> wrote:
> > >
> > > The panel-edp driver modes needs to be validated differently from DP
> > > because the link capabilities are not available for EDP by that time.
> > >
> > > Signed-off-by: Sankeerth Billakanti <quic_sbillaka@quicinc.com>
> >
> > This should not be necessary after
> > https://patchwork.freedesktop.org/patch/479261/?series=101682&rev=1.
> > Could you please check?
> >
>
> The check for DP_MAX_PIXEL_CLK_KHZ is not necessary anymore but we need
> to return early for eDP because unlike DP, eDP context will not have the information
> about the number of lanes and link clock.
>
> So, I will modify the patch to return after the DP_MAX_PIXEL_CLK_KHZ check if is_eDP is set.

I haven't walked through all the relevant code but something you said
above sounds strange. You say that for eDP we don't have info about
the number of lanes? We _should_.

It's certainly possible to have a panel that supports _either_ 1 or 2
lanes but then only physically connect 1 lane to it. ...or you could
have a panel that supports 2 or 4 lanes and you only connect 1 lane.
See, for instance, ti_sn_bridge_parse_lanes. There we assume 4 lanes
but if a "data-lanes" property is present then we can use that to know
that fewer lanes are physically connected.

It's also possible to connect more lanes to a panel than it supports.
You could connect 2 lanes to it but then it only supports 1. This case
needs to be handled as well...


-Doug

\
 
 \ /
  Last update: 2022-04-01 01:33    [W:0.097 / U:0.968 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site