lkml.org 
[lkml]   [2022]   [Mar]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [BUG] usb: typec: ucsi: possible deadlock in ucsi_pr_swap() and ucsi_handle_connector_change()
On Fri, Mar 25, 2022 at 01:39:59PM -0700, Jack Pham wrote:
> Hi Heikki,
>
> On Wed, Feb 09, 2022 at 04:30:31PM +0200, Heikki Krogerus wrote:
> > On Wed, Feb 09, 2022 at 11:50:57AM +0800, Jia-Ju Bai wrote:
> > > Hello,
> > >
> > > My static analysis tool reports a possible deadlock in the ucsi driver in
> > > Linux 5.16:
> > >
> > > ucsi_pr_swap()
> > >   mutex_lock(&con->lock); --> Line 962 (Lock A)
> > >   wait_for_completion_timeout(&con->complete, ...) --> Line 981 (Wait X)
> > >
> > > ucsi_handle_connector_change()
> > >   mutex_lock(&con->lock); --> Line 763 (Lock A)
> > >   complete(&con->complete); --> Line 782 (Wake X)
> > >   complete(&con->complete); --> Line 807 (Wake X)
> > >
> > > When ucsi_pr_swap() is executed, "Wait X" is performed by holding "Lock A".
> > > If ucsi_handle_connector_change() is executed at this time, "Wake X" cannot
> > > be performed to wake up "Wait X" in ucsi_handle_connector_change(), because
> > > "Lock A" has been already held by ucsi_handle_connector_change(), causing a
> > > possible deadlock.
> > > I find that "Wait X" is performed with a timeout, to relieve the possible
> > > deadlock; but I think this timeout can cause inefficient execution.
> > >
> > > I am not quite sure whether this possible problem is real.
> > > Any feedback would be appreciated, thanks :)
> >
> > This is probable a regression from commit ad74b8649bea ("usb: typec:
> > ucsi: Preliminary support for alternate modes"). Can you test does
> > this patch fix the issue (attached)?
>
> We encountered a slightly different twist to this bug. Instead of
> deadlocking, we see that the dr_swap() / pr_swap() operations actually
> jump out of the wait_for_completion_timeout() immediately, even before
> any partner change occurs. This is because the con->complete may
> already have its done flag set to true from the first time
> ucsi_handle_connector_change() runs, and is never reset after that.
>
> In addition to the unlocking below, I think we need to also add
> reinit_completion() calls at the start of ucsi_{pr,dr}_swap().

OK. I'll add that to the patch.

thanks,

--
heikki

\
 
 \ /
  Last update: 2022-03-28 10:30    [W:0.069 / U:1.436 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site