lkml.org 
[lkml]   [2022]   [Mar]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v6 2/2] ath10k: Trigger sta disconnect on hardware restart
From
Date
Youghandhar Chintala <youghand@codeaurora.org> wrote:

> Currently after the hardware restart triggered from the driver,
> the station interface connection remains intact, since a disconnect
> trigger is not sent to userspace. This can lead to a problem in
> targets where the wifi mac sequence is added by the firmware.
>
> After the target restart, its wifi mac sequence number gets
> reset to zero. Hence AP to which our device is connected will receive
> frames with a wifi mac sequence number jump to the past, thereby
> resulting in the AP dropping all these frames, until the frame
> arrives with a wifi mac sequence number which AP was expecting.
>
> To avoid such frame drops, its better to trigger a station disconnect
> upon target hardware restart which can be done with API
> ieee80211_reconfig_disconnect exposed to mac80211.
>
> The other targets are not affected by this change, since the hardware
> params flag is not set.
>
> Tested-on: WCN3990 hw1.0 SNOC WLAN.HL.3.1-01040-QCAHLSWMTPLZ-1
> Tested-on: QCA6174 hw3.2 PCI WLAN.RM.4.4.1-00110-QCARMSWP-1
> Tested-on: QCA6174 hw3.2 SDIO WLAN.RMH.4.4.1-00048
>
> Signed-off-by: Youghandhar Chintala <youghand@codeaurora.org>
> Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>

Patch applied to ath-next branch of ath.git, thanks.

2c3fc50591ff ath10k: Trigger sta disconnect on hardware restart

--
https://patchwork.kernel.org/project/linux-wireless/patch/20220315082944.12406-3-youghand@codeaurora.org/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches

\
 
 \ /
  Last update: 2022-03-21 11:47    [W:0.041 / U:0.264 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site