lkml.org 
[lkml]   [2022]   [Mar]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v1 3/5] iio: accel: bma400: Add triggered buffer support
Hello Andy,

On Mon, Mar 21, 2022 at 10:39:22AM +0200, Andy Shevchenko wrote:
> On Sat, Mar 19, 2022 at 8:10 PM Jagath Jog J <jagathjog1996@gmail.com> wrote:
> >
> > Added trigger buffer support to read continuous acceleration
> > data from device with data ready interrupt which is mapped
> > to INT1 pin.
>
> ...
>
> > #include <linux/mutex.h>
> > #include <linux/regmap.h>
> > #include <linux/regulator/consumer.h>
> > +#include <linux/bits.h>
> > +#include <linux/bitfield.h>
>
> It would be nice to keep the above in order.
>
> > +#include <linux/iio/buffer.h>
> > +#include <linux/iio/trigger.h>
> > +#include <linux/iio/triggered_buffer.h>
> > +#include <linux/iio/trigger_consumer.h>
>
> These ones, possibly including iio headers from the above piece, are
> good to be grouped together here with a blank line in between the
> above part and iio/*.
>
> ...
>
> > +static const unsigned long bma400_avail_scan_masks[] = {
> > + GENMASK(3, 0),
>
> > + 0,
>
> No need to have a comma in terminator entry.
>
> > +};
>
> ...
>
> > + ret = regmap_bulk_read(data->regmap, BMA400_X_AXIS_LSB_REG,
> > + &data->buffer.buff, 3 * sizeof(__be16));
>
> sizeof(buff)
>
> ...
>
> > +out:

Just to skip the below "if()" if error occurs in previous regmap read,
I used this label.
if (status & BMA400_INT_DRDY_MSK)
iio_trigger_poll_chained(data->trig);

I will remove the label in next patch
>
> A useless label. Moreover this raises a question: why is it okay to
> always mark IRQ as handled?
>
> > + return IRQ_HANDLED;

Since I was not using top-half of the interrupt so I marked IRQ as handled
even for error case in the handler.

>
> ...
>
> > + dev_err(dev, "iio trigger register failed\n");
> > + return ret;
>
> return dev_err_probe();
>
> ...
>
> > + dev_err(dev, "request irq %d failed\n", irq);
> > + return ret;
>
> Ditto.
>
> ...
>
> > + dev_err(dev, "iio triggered buffer setup failed\n");
> > + return ret;
>
> Ditto.

I will change this in the next patch version.
>
> --
> With Best Regards,
> Andy Shevchenko

\
 
 \ /
  Last update: 2022-03-21 23:52    [W:0.092 / U:0.352 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site