Messages in this thread | | | Date | Wed, 2 Feb 2022 12:01:37 +0100 | Subject | Re: [PATCH 3/3] arm64: dts: rockchip: Add Pine64 PineNote board | From | Johan Jonker <> |
| |
On 2/2/22 11:41, Johan Jonker wrote: > Hi Samuel,
> On 1/30/22 06:38, Samuel Holland wrote:
>> +/ { >> + aliases {
>> + mmc0 = &sdhci;
sdmmc1 ??
MMC aliases should be sort on reg address, based on availability and without number gap.
>> + }; >> +
[..]
>> +&sdhci { >> + bus-width = <8>; >> + mmc-hs200-1_8v; >> + non-removable; >> + pinctrl-0 = <&emmc_bus8>, <&emmc_clk>, <&emmc_cmd>, <&emmc_datastrobe>, <&emmc_rstnout>; >> + pinctrl-names = "default"; >> + vmmc-supply = <&vcc_3v3>; >> + vqmmc-supply = <&vcc_1v8>; >> + status = "okay"; >> +}; >> + >> +&sdmmc1 { >> + bus-width = <4>; >> + cap-sd-highspeed; >> + cap-sdio-irq; > >> + disable-wp; > > From mmc-controller.yaml: > > disable-wp: > $ref: /schemas/types.yaml#/definitions/flag > description: > When set, no physical write-protect line is present. This > property should only be specified when the controller has a > dedicated write-protect detection logic. If a GPIO is always used > for the write-protect detection logic, it is sufficient to not > specify the wp-gpios property in the absence of a write-protect > line. Not used in combination with eMMC or SDIO. > >> + keep-power-in-suspend; >> + mmc-pwrseq = <&sdio_pwrseq>; >> + non-removable; >> + pinctrl-0 = <&sdmmc1_bus4>, <&sdmmc1_clk>, <&sdmmc1_cmd>; >> + pinctrl-names = "default"; >> + sd-uhs-sdr104; >> + vmmc-supply = <&vcc_wl>; >> + vqmmc-supply = <&vcca_1v8_pmu>; >> + status = "okay"; >> +}; >> +
| |