lkml.org 
[lkml]   [2022]   [Feb]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/9] serial: stm32: remove redundant code in rs485_config
Date
When RS485 is configured by userspace the serial core already ensures valid
RTS settings and assigns the configuration to the uart port. So remove
these tasks from the code of the drivers config_rs485 function to avoid
redundancy.

Signed-off-by: Lino Sanfilippo <LinoSanfilippo@gmx.de>
---
drivers/tty/serial/stm32-usart.c | 9 ++-------
1 file changed, 2 insertions(+), 7 deletions(-)

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 1b3a611ac39e..6a014168102c 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -107,8 +107,6 @@ static int stm32_usart_config_rs485(struct uart_port *port,

stm32_usart_clr_bits(port, ofs->cr1, BIT(cfg->uart_enable_bit));

- port->rs485 = *rs485conf;
-
rs485conf->flags |= SER_RS485_RX_DURING_TX;

if (rs485conf->flags & SER_RS485_ENABLED) {
@@ -128,13 +126,10 @@ static int stm32_usart_config_rs485(struct uart_port *port,
rs485conf->delay_rts_after_send,
baud);

- if (rs485conf->flags & SER_RS485_RTS_ON_SEND) {
+ if (rs485conf->flags & SER_RS485_RTS_ON_SEND)
cr3 &= ~USART_CR3_DEP;
- rs485conf->flags &= ~SER_RS485_RTS_AFTER_SEND;
- } else {
+ else
cr3 |= USART_CR3_DEP;
- rs485conf->flags |= SER_RS485_RTS_AFTER_SEND;
- }

writel_relaxed(cr3, port->membase + ofs->cr3);
writel_relaxed(cr1, port->membase + ofs->cr1);
--
2.34.1
\
 
 \ /
  Last update: 2022-02-13 23:34    [W:0.063 / U:0.732 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site