lkml.org 
[lkml]   [2022]   [Dec]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v3] regulator: dt-bindings: qcom,rpmh: Indicate regulator-allow-set-load dependencies
From
On 07/09/2022 22:49, Andrew Halaney wrote:
> For RPMH regulators it doesn't make sense to indicate
> regulator-allow-set-load without saying what modes you can switch to,
> so be sure to indicate a dependency on regulator-allowed-modes.
>
> In general this is true for any regulators that are setting modes
> instead of setting a load directly, for example RPMH regulators. A
> counter example would be RPM based regulators, which set a load
> change directly instead of a mode change. In the RPM case
> regulator-allow-set-load alone is sufficient to describe the regulator
> (the regulator can change its output current, here's the new load),
> but in the RPMH case what valid operating modes exist must also be
> stated to properly describe the regulator (the new load is this, what
> is the optimum mode for this regulator with that load, let's change to
> that mode now).
>
> With this in place devicetree validation can catch issues like this:
>
> /mnt/extrassd/git/linux-next/arch/arm64/boot/dts/qcom/sm8350-hdk.dtb: pm8350-rpmh-regulators: ldo5: 'regulator-allowed-modes' is a dependency of 'regulator-allow-set-load'
> From schema: /mnt/extrassd/git/linux-next/Documentation/devicetree/bindings/regulator/qcom,rpmh-regulator.yaml

Andrew,

This patch was merged therefore we started seeing such warnings. Any
plans to actually fix them?

Best regards,
Krzysztof

\
 
 \ /
  Last update: 2023-03-26 23:22    [W:0.102 / U:0.764 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site