lkml.org 
[lkml]   [2022]   [Dec]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 1/2] ip/ip6_gre: Fix changing addr gen mode not generating IPv6 link local address
From
Date
On Mon, 2022-12-19 at 14:06 +1300, Thomas Winter wrote:
> Commit e5dd729460ca changed the code path so that GRE tunnels
> generate an IPv6 address based on the tunnel source address.
> It also changed the code path so GRE tunnels don't call addrconf_addr_gen
> in addrconf_dev_config which is called by addrconf_sysctl_addr_gen_mode
> when the IN6_ADDR_GEN_MODE is changed.
>
> This patch aims to fix this issue by moving the code in addrconf_notify
> which calls the addr gen for GRE and SIT into a separate function
> and calling it in the places that expect the IPv6 address to be
> generated.
>
> The previous addrconf_dev_config is renamed to addrconf_eth_config
> since it only expected eth type interfaces and follows the
> addrconf_gre/sit_config format.
>
> Fixes: e5dd729460ca ("ip/ip6_gre: use the same logic as SIT interfaces when computing v6LL address")
> Signed-off-by: Thomas Winter <Thomas.Winter@alliedtelesis.co.nz>
> ---
> net/ipv6/addrconf.c | 47 +++++++++++++++++++++++++--------------------
> 1 file changed, 26 insertions(+), 21 deletions(-)
>
> diff --git a/net/ipv6/addrconf.c b/net/ipv6/addrconf.c
> index 6dcf034835ec..e9d7ec03316d 100644
> --- a/net/ipv6/addrconf.c
> +++ b/net/ipv6/addrconf.c
> @@ -3355,7 +3355,7 @@ static void addrconf_addr_gen(struct inet6_dev *idev, bool prefix_route)
> }
> }
>
> -static void addrconf_dev_config(struct net_device *dev)
> +static void addrconf_eth_config(struct net_device *dev)

You are creating a new function with the name of an existing one, while
renaming the latter. IMHO this makes the patch hard to review as there
are some existing call side for the old name, which we likelly want to
explicitly see here.

> {
> struct inet6_dev *idev;
>
> @@ -3447,6 +3447,30 @@ static void addrconf_gre_config(struct net_device *dev)
> }
> #endif
>
> +static void addrconf_dev_config(struct net_device *dev)
> +{
> + switch (dev->type) {
> +#if IS_ENABLED(CONFIG_IPV6_SIT)
> + case ARPHRD_SIT:
> + addrconf_sit_config(dev);
> + break;
> +#endif
> +#if IS_ENABLED(CONFIG_NET_IPGRE) || IS_ENABLED(CONFIG_IPV6_GRE)
> + case ARPHRD_IP6GRE:
> + case ARPHRD_IPGRE:
> + addrconf_gre_config(dev);
> + break;
> +#endif
> + case ARPHRD_LOOPBACK:
> + init_loopback(dev);
> + break;

If I read correctly, this change will cause unneeded attempt to re-add
the loopback address on the loopback device when the lo.addr_gen_mode
sysfs entry is touched. I think such side effect should be avoided.

Thanks,

Paolo

\
 
 \ /
  Last update: 2023-03-26 23:15    [W:0.152 / U:0.304 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site