lkml.org 
[lkml]   [2022]   [Dec]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v7 1/6] DONOTMERGE: arm64: dts: ti: Add TI TPS65219 PMIC support for AM642 SK board.
From


On 16/12/22 03:11, Nishanth Menon wrote:
> On 18:22-20221215, Mark Brown wrote:
>> On Thu, Dec 15, 2022 at 11:54:11AM -0600, Nishanth Menon wrote:
>>> On 16:09-20221215, Mark Brown wrote:
>>
>>>> That proposal looks really non-idiomatic and quite unusual, if there's a
>>>> fixed voltage supply to the LDO I'd expect to see it modeled as a fixed
>>>> voltage regulator. I'm not sure what the use of bypass here is trying
>>>> to accomplish TBH.
>>
>>> The problem is this - the default NVM in the PMIC is setup such that
>>> VSET value =3.3v and bypass bit set (makes sense since the vin=3.3v).
>>
>> This implies no voltage drop over the LDO? Sounds a bit suspect.
>
> Not the choice I'd probably have made ;)
>
>>
>>> Now the constraint is bypass bit cannot be changed without the LDO
>>> being switched off.
>>

Per https://www.ti.com/lit/ds/symlink/tps65219.pdf (7.3.6 Linear
Regulators).

LDOs have two modes:

1. Load switch mode: in this case, output voltages of 1.5V up to 5.5V
are supported.

2 Linear regulator LDO mode where output voltage is programmable in the
range of 0.6V to 3.4V in 50mV-steps with possibility of bypass.

(CAUTION on page 25):
A mode change between LDO(/bypass) and LSW-mode must only be performed,
when this regulator is disabled!
A change between LDO and bypass-mode (supported by LDO1 and LDO2 only)
is supported during operation.

So, seems like bypass can be toggled even with LDO on?



[...]

Regards
Vignesh

\
 
 \ /
  Last update: 2022-12-16 07:23    [W:0.071 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site