lkml.org 
[lkml]   [2022]   [Nov]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/5] dt-bindings: net: add schema for NXP S32CC dwmac glue driver
Hi Andrew,

On Fri, Nov 04, 2022 at 02:30:11PM +0100, Andrew Lunn wrote:
> > Here I just focus on GMAC since there are other LAN interfaces that S32 family
> > uses [e.g. PFE]. According to the public GMACSUBSYS ref manual rev2[1] provided
> > on NXP website, theoretically GMAC can run SGMII in 1000Mbps and 2500Mbps so I
> > assume that supporting 1000BASE-X could be achievable. I'm not sure if any S32
> > board variant might have SFP ports but RJ-45 [1000BASE-T] should be the major
> > type used on S32G-EVB and S32G-RDB2.
>
> SGMII at 2500Mbps does not exist. Lots of people get this wrong. It
> will be 2500Base-X.
>

Thanks for your correction.

> Does the clock need to change in order to support 2500Base-X? If i

Since I'm not a hardware designer from NXP and I can't find any board that
S32G2 CPUs could integrate SFP, so I am not able to tell how the clock could
be configured while supporting 2500Base-X.

> understand you correctly, Linux does not control the clocks, and so
> cannot change the clocks? So that probably means you cannot actually

To be more precise, the SCMI clock protocol in ATF [ARM Trusted Firmware]
doesn't design any interface to get/set parents of a clock so that re-parenting
clocks via the SCMI clk driver [clk-scmi.c] in Linux Kernel is impossible
for this case. That means, if any board design allows run-time swap on different
phys, the dedicated clks which represent each phy-mode are required in order
to trigger clock re-parenting in ATF since different phy connections would
need different clock sources.

> support 2500Base-X? Once you have Linux actually controlling the
> hardware, you can then make use of an SFP or a copper PHY which
> supports 2.5G. The PHY will swap its host side between SGMII and
> 2500Base-X depending on what the line side negotiates, 1000Base-T or
> 2500Base-T. The MAC driver then needs to change its configuration to
> suite.
>
> Andrew

\
 
 \ /
  Last update: 2022-11-09 09:10    [W:0.108 / U:0.088 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site