Messages in this thread | | | Date | Tue, 8 Nov 2022 17:34:43 +0530 | Subject | Re: [PATCH v2] wifi: ath10k: Add WLAN firmware image version info into smem | From | "Youghandhar Chintala (Temp)" <> |
| |
On 11/8/2022 4:00 PM, Kalle Valo wrote: > Youghandhar Chintala <quic_youghand@quicinc.com> wrote: > >> In a SoC based solution, it would be useful to know the versions of the >> various binary firmware blobs the system is running on. On a QCOM based >> SoC, this info can be obtained from socinfo debugfs infrastructure. For >> this to work, respective subsystem drivers have to export the firmware >> version information to an SMEM based version information table. >> >> Having firmware version information at one place will help quickly >> figure out the firmware versions of various subsystems on the device >> instead of going through builds/logs in an event of a system crash. >> >> Fill WLAN firmware version information in SMEM version table to be >> printed as part of socinfo debugfs infrastructure on a Qualcomm based >> SoC. >> >> This change is applicable only for WCN399X targets. >> >> Reported-by: kernel test robot <lkp@intel.com> >> >> Tested-on: WCN3990 hw1.0 SNOC WLAN.HL.3.2.2.c10-00754-QCAHLSWMTPL-1 >> >> Signed-off-by: Youghandhar Chintala <quic_youghand@quicinc.com> >> Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com> > This doesn't compile unless QCOM_SMEM is enabled in Kconfig. So should we add > "select QCOM_SMEM" in Kconfig for ATH10K_SNOC?
Yes Kalle. Thank you.
Regards,
Youghandhar
| |