lkml.org 
[lkml]   [2022]   [Nov]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    SubjectRe: [PATCH 2/3] arm64: dts: qcom: hk10: use GPIO flags for tlmm
    From


    On 07/11/2022 10:29, Robert Marko wrote:
    > Use respective GPIO_ACTIVE_LOW/HIGH flags for tlmm GPIOs instead of
    > harcoding the cell value.
    >
    > Signed-off-by: Robert Marko <robimarko@gmail.com>
    > ---
    Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>

    KOnrad
    > arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi | 5 +++--
    > 1 file changed, 3 insertions(+), 2 deletions(-)
    >
    > diff --git a/arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi b/arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi
    > index 262b937e0bc6..651a231554e0 100644
    > --- a/arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi
    > +++ b/arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi
    > @@ -5,6 +5,7 @@
    > /dts-v1/;
    >
    > #include "ipq8074.dtsi"
    > +#include <dt-bindings/gpio/gpio.h>
    >
    > / {
    > aliases {
    > @@ -39,12 +40,12 @@ &blsp1_uart5 {
    >
    > &pcie0 {
    > status = "okay";
    > - perst-gpios = <&tlmm 58 0x1>;
    > + perst-gpios = <&tlmm 58 GPIO_ACTIVE_LOW>;
    > };
    >
    > &pcie1 {
    > status = "okay";
    > - perst-gpios = <&tlmm 61 0x1>;
    > + perst-gpios = <&tlmm 61 GPIO_ACTIVE_LOW>;
    > };
    >
    > &pcie_phy0 {

    \
     
     \ /
      Last update: 2022-11-07 10:58    [W:2.977 / U:0.432 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site