lkml.org 
[lkml]   [2022]   [Nov]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH 1/1] iio: imx8qxp-adc: fix irq flood when call imx8qxp_adc_read_raw()
Date
> -----Original Message-----
> From: Frank Li <frank.li@nxp.com>
> Sent: 2022年11月30日 0:46
> To: Cai Huoqing <cai.huoqing@linux.dev>; Bough Chen <haibo.chen@nxp.com>;
> Jonathan Cameron <jic23@kernel.org>; Lars-Peter Clausen <lars@metafoo.de>;
> Shawn Guo <shawnguo@kernel.org>; Sascha Hauer <s.hauer@pengutronix.de>;
> Pengutronix Kernel Team <kernel@pengutronix.de>; Fabio Estevam
> <festevam@gmail.com>; dl-linux-imx <linux-imx@nxp.com>; open list:NXP i.MX
> 8QXP ADC DRIVER <linux-iio@vger.kernel.org>; moderated
> list:ARM/FREESCALE IMX / MXC ARM ARCHITECTURE
> <linux-arm-kernel@lists.infradead.org>; open list <linux-kernel@vger.kernel.org>
> Cc: imx@lists.linux.dev
> Subject: [PATCH 1/1] iio: imx8qxp-adc: fix irq flood when call
> imx8qxp_adc_read_raw()
>
> irq flood happen when run
> cat /sys/bus/iio/devices/iio:device0/in_voltage1_raw
>
> imx8qxp_adc_read_raw()
> {
> ...
> enable irq
> /* adc start */
> writel(1, adc->regs + IMX8QXP_ADR_ADC_SWTRIG);
> ^^^^ trigger irq flood.
> wait_for_completion_interruptible_timeout();
> readl(adc->regs + IMX8QXP_ADR_ADC_RESFIFO);
> ^^^^ clear irq here.
> ...
> }
>
> There is only FIFO watermark interrupt at this ADC controller.
> IRQ line will be assert until software read data from FIFO.
> So IRQ flood happen during wait_for_completion_interruptible_timeout().
>
> Move FIFO read into irq handle to avoid irq flood.
>
> Fixes: 1e23dcaa1a9f ("iio: imx8qxp-adc: Add driver support for NXP IMX8QXP
> ADC")
> Cc: stable@vger.kernel.org
>
> Signed-off-by: Frank Li <Frank.Li@nxp.com>
> ---
> drivers/iio/adc/imx8qxp-adc.c | 11 +++++++++--
> 1 file changed, 9 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/iio/adc/imx8qxp-adc.c b/drivers/iio/adc/imx8qxp-adc.c index
> 36777b827165..3cfba5c0fa34 100644
> --- a/drivers/iio/adc/imx8qxp-adc.c
> +++ b/drivers/iio/adc/imx8qxp-adc.c
> @@ -86,6 +86,8 @@
>
> #define IMX8QXP_ADC_TIMEOUT msecs_to_jiffies(100)
>
> +#define IMX8QXP_ADC_MAX_FIFO_SIZE 16
> +
> struct imx8qxp_adc {
> struct device *dev;
> void __iomem *regs;
> @@ -95,6 +97,7 @@ struct imx8qxp_adc {
> /* Serialise ADC channel reads */
> struct mutex lock;
> struct completion completion;
> + u32 fifo[IMX8QXP_ADC_MAX_FIFO_SIZE];
> };
>
> #define IMX8QXP_ADC_CHAN(_idx) { \
> @@ -238,8 +241,7 @@ static int imx8qxp_adc_read_raw(struct iio_dev
> *indio_dev,
> return ret;
> }
>
> - *val = FIELD_GET(IMX8QXP_ADC_RESFIFO_VAL_MASK,
> - readl(adc->regs + IMX8QXP_ADR_ADC_RESFIFO));
> + *val = adc->fifo[0];
>
> mutex_unlock(&adc->lock);
> return IIO_VAL_INT;
> @@ -265,6 +267,7 @@ static irqreturn_t imx8qxp_adc_isr(int irq, void *dev_id)
> {
> struct imx8qxp_adc *adc = dev_id;
> u32 fifo_count;
> + int i;
>
> fifo_count = FIELD_GET(IMX8QXP_ADC_FCTRL_FCOUNT_MASK,
> readl(adc->regs + IMX8QXP_ADR_ADC_FCTRL)); @@
> -272,6 +275,10 @@ static irqreturn_t imx8qxp_adc_isr(int irq, void *dev_id)
> if (fifo_count)
> complete(&adc->completion);
>
> + for (i = 0; i < fifo_count; i++)
> + adc->fifo[i] = FIELD_GET(IMX8QXP_ADC_RESFIFO_VAL_MASK,
> + readl_relaxed(adc->regs + IMX8QXP_ADR_ADC_RESFIFO));

Hi Frank,

Since the ADC mode is config as single-ended 12-bit conversion, every time when trigger the ADC conversion, only one 12-bit data push into fifo.
And we also config the fifo watermark as 1. So here only need to read once. I already confirmed on my board.

Best Regards
Haibo Chen
> +
> return IRQ_HANDLED;
> }
>
> --
> 2.34.1

\
 
 \ /
  Last update: 2022-11-30 10:58    [W:0.063 / U:2.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site