lkml.org 
[lkml]   [2022]   [Nov]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH rcu 15/16] net: Use call_rcu_hurry() for dst_release()
Hi Eric,

On Wed, Nov 30, 2022 at 6:39 PM Eric Dumazet <edumazet@google.com> wrote:
>
> Sure, thanks.
>
> Reviewed-by: Eric Dumazet <edumazet@google.com>
>
> I think we can work later to change how dst are freed/released to
> avoid using call_rcu_hurry()

That sounds great, if you can give me any high-level guidance (in the
future) on that and what to look for, I can give it a try as well. I
have been wanting to learn more about the networking code :-)

Thanks,

- Joel


> On Wed, Nov 30, 2022 at 7:17 PM Joel Fernandes <joel@joelfernandes.org> wrote:
> >
> > Hi Eric,
> >
> > Could you give your ACK for this patch for this one as well? This is
> > the other networking one.
> >
> > The networking testing passed on ChromeOS and it has been in -next for
> > some time so has gotten testing there. The CONFIG option is default
> > disabled.
> >
> > Thanks a lot,
> >
> > - Joel
> >
> > On Wed, Nov 30, 2022 at 6:14 PM Paul E. McKenney <paulmck@kernel.org> wrote:
> > >
> > > From: "Joel Fernandes (Google)" <joel@joelfernandes.org>
> > >
> > > In a networking test on ChromeOS, kernels built with the new
> > > CONFIG_RCU_LAZY=y Kconfig option fail a networking test in the teardown
> > > phase.
> > >
> > > This failure may be reproduced as follows: ip netns del <name>
> > >
> > > The CONFIG_RCU_LAZY=y Kconfig option was introduced by earlier commits
> > > in this series for the benefit of certain battery-powered systems.
> > > This Kconfig option causes call_rcu() to delay its callbacks in order
> > > to batch them. This means that a given RCU grace period covers more
> > > callbacks, thus reducing the number of grace periods, in turn reducing
> > > the amount of energy consumed, which increases battery lifetime which
> > > can be a very good thing. This is not a subtle effect: In some important
> > > use cases, the battery lifetime is increased by more than 10%.
> > >
> > > This CONFIG_RCU_LAZY=y option is available only for CPUs that offload
> > > callbacks, for example, CPUs mentioned in the rcu_nocbs kernel boot
> > > parameter passed to kernels built with CONFIG_RCU_NOCB_CPU=y.
> > >
> > > Delaying callbacks is normally not a problem because most callbacks do
> > > nothing but free memory. If the system is short on memory, a shrinker
> > > will kick all currently queued lazy callbacks out of their laziness,
> > > thus freeing their memory in short order. Similarly, the rcu_barrier()
> > > function, which blocks until all currently queued callbacks are invoked,
> > > will also kick lazy callbacks, thus enabling rcu_barrier() to complete
> > > in a timely manner.
> > >
> > > However, there are some cases where laziness is not a good option.
> > > For example, synchronize_rcu() invokes call_rcu(), and blocks until
> > > the newly queued callback is invoked. It would not be a good for
> > > synchronize_rcu() to block for ten seconds, even on an idle system.
> > > Therefore, synchronize_rcu() invokes call_rcu_hurry() instead of
> > > call_rcu(). The arrival of a non-lazy call_rcu_hurry() callback on a
> > > given CPU kicks any lazy callbacks that might be already queued on that
> > > CPU. After all, if there is going to be a grace period, all callbacks
> > > might as well get full benefit from it.
> > >
> > > Yes, this could be done the other way around by creating a
> > > call_rcu_lazy(), but earlier experience with this approach and
> > > feedback at the 2022 Linux Plumbers Conference shifted the approach
> > > to call_rcu() being lazy with call_rcu_hurry() for the few places
> > > where laziness is inappropriate.
> > >
> > > Returning to the test failure, use of ftrace showed that this failure
> > > cause caused by the aadded delays due to this new lazy behavior of
> > > call_rcu() in kernels built with CONFIG_RCU_LAZY=y.
> > >
> > > Therefore, make dst_release() use call_rcu_hurry() in order to revert
> > > to the old test-failure-free behavior.
> > >
> > > [ paulmck: Apply s/call_rcu_flush/call_rcu_hurry/ feedback from Tejun Heo. ]
> > >
> > > Signed-off-by: Joel Fernandes (Google) <joel@joelfernandes.org>
> > > Cc: David Ahern <dsahern@kernel.org>
> > > Cc: "David S. Miller" <davem@davemloft.net>
> > > Cc: Eric Dumazet <edumazet@google.com>
> > > Cc: Hideaki YOSHIFUJI <yoshfuji@linux-ipv6.org>
> > > Cc: Jakub Kicinski <kuba@kernel.org>
> > > Cc: Paolo Abeni <pabeni@redhat.com>
> > > Cc: <netdev@vger.kernel.org>
> > > Signed-off-by: Paul E. McKenney <paulmck@kernel.org>
> > > ---
> > > net/core/dst.c | 2 +-
> > > 1 file changed, 1 insertion(+), 1 deletion(-)
> > >
> > > diff --git a/net/core/dst.c b/net/core/dst.c
> > > index bc9c9be4e0801..a4e738d321ba2 100644
> > > --- a/net/core/dst.c
> > > +++ b/net/core/dst.c
> > > @@ -174,7 +174,7 @@ void dst_release(struct dst_entry *dst)
> > > net_warn_ratelimited("%s: dst:%p refcnt:%d\n",
> > > __func__, dst, newrefcnt);
> > > if (!newrefcnt)
> > > - call_rcu(&dst->rcu_head, dst_destroy_rcu);
> > > + call_rcu_hurry(&dst->rcu_head, dst_destroy_rcu);
> > > }
> > > }
> > > EXPORT_SYMBOL(dst_release);
> > > --
> > > 2.31.1.189.g2e36527f23
> > >

\
 
 \ /
  Last update: 2022-11-30 19:51    [W:0.054 / U:0.760 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site