lkml.org 
[lkml]   [2022]   [Nov]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH] ARM: dts: at91: sama7g5ek: align power rails for sdmmc0/1
Date
On 24.11.2022 17:46, Eugen Hristev wrote:
> On this board SDMMC0 has a 1.8 signaled eMMC device powered at
> 3.3 V .
> Hence, correctly describe the connected rails from the PMIC.
>
> SDMMC1 is connected to a voltage switch that can change from
> 3.3V to 1.8V by a hardware controlled pin.
> However SDMMC1 at the moment works only 3.3V mode (default speed,
> no UHS-I modes), thus connect the signaling to the 3.3V rail.
>
> Signed-off-by: Eugen Hristev <eugen.hristev@microchip.com>

Applied to at91-dt (after reshaped a bit the commit message), thanks!

> ---
> arch/arm/boot/dts/at91-sama7g5ek.dts | 5 ++++-
> 1 file changed, 4 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm/boot/dts/at91-sama7g5ek.dts b/arch/arm/boot/dts/at91-sama7g5ek.dts
> index 3b25c67795dd..aa5cc0e98bba 100644
> --- a/arch/arm/boot/dts/at91-sama7g5ek.dts
> +++ b/arch/arm/boot/dts/at91-sama7g5ek.dts
> @@ -764,8 +764,9 @@ &rtt {
> &sdmmc0 {
> bus-width = <8>;
> non-removable;
> - no-1-8-v;
> sdhci-caps-mask = <0x0 0x00200000>;
> + vmmc-supply = <&vdd_3v3>;
> + vqmmc-supply = <&vldo1>;
> pinctrl-names = "default";
> pinctrl-0 = <&pinctrl_sdmmc0_default>;
> status = "okay";
> @@ -775,6 +776,8 @@ &sdmmc1 {
> bus-width = <4>;
> no-1-8-v;
> sdhci-caps-mask = <0x0 0x00200000>;
> + vmmc-supply = <&vdd_3v3>;
> + vqmmc-supply = <&vdd_3v3>;
> pinctrl-names = "default";
> pinctrl-0 = <&pinctrl_sdmmc1_default>;
> status = "okay";

\
 
 \ /
  Last update: 2022-11-25 12:35    [W:0.141 / U:0.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site