lkml.org 
[lkml]   [2022]   [Nov]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 0/3] iio: adc: stm32: add smart calibration
From
On 11/15/22 11:31, Olivier Moysan wrote:
> Refine offset and linear calibration strategy for STM32MP15 and
> STM32MP13 SoCs:
>
> - offset calibration
> This calibration depends on factors such as temperature and voltage.
> As it is not time consuming, it's worth doing it on each ADC
> start, to get the best accuracy. There is no need to save these data.
>
> - linear calibration
> This calibration is basically SoC dependent, so it can be done only once.
> When this calibration has been performed at boot stage, the ADC kernel
> driver can retrieve the calibration data from the ADC registers.
> Otherwise, the linear calibration is performed once by the ADC driver.
> The backup of these data, allows to restore them on successive ADC starts.
>
> Olivier Moysan (3):
> iio: adc: stm32-adc: smart calibration support
> iio: adc: stm32-adc: improve calibration error log
> iio: adc: stm32-adc: add debugfs to read raw calibration result

Hi Olivier,

For the series, you can add my:
Reviewed-by: Fabrice Gasnier <fabrice.gasnier@foss.st.com>

Thanks,
Fabrice

>
> drivers/iio/adc/stm32-adc-core.h | 1 +
> drivers/iio/adc/stm32-adc.c | 135 ++++++++++++++++++-------------
> 2 files changed, 78 insertions(+), 58 deletions(-)
>

\
 
 \ /
  Last update: 2022-11-23 12:09    [W:0.059 / U:0.440 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site