Messages in this thread Patch in this message | | | From | Matt Ranostay <> | Subject | [PATCH v7 5/8] arm64: dts: ti: k3-j721s2-common-proc-board: Add USB support | Date | Tue, 22 Nov 2022 02:16:13 -0800 |
| |
From: Aswath Govindraju <a-govindraju@ti.com>
The board uses lane 1 of SERDES for USB. Set the mux accordingly.
The USB controller and EVM supports super-speed for USB0 on the Type-C port. However, the SERDES has a limitation that upto 2 protocols can be used at a time. The SERDES is wired for PCIe, eDP and USB super-speed. It has been chosen to use PCIe and eDP as default. So restrict USB0 to high-speed mode.
Reviewed-by: Ravi Gunasekaran <r-gunasekaran@ti.com> Signed-off-by: Aswath Govindraju <a-govindraju@ti.com> Signed-off-by: Matt Ranostay <mranostay@ti.com> --- .../dts/ti/k3-j721s2-common-proc-board.dts | 22 +++++++++++++++++++ 1 file changed, 22 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts index c3a397484c70..c787d46f89de 100644 --- a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts +++ b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts @@ -147,6 +147,12 @@ vdd_sd_dv_pins_default: vdd-sd-dv-pins-default { J721S2_IOPAD(0x020, PIN_INPUT, 7) /* (AA23) MCAN15_RX.GPIO0_8 */ >; }; + + main_usbss0_pins_default: main-usbss0-pins-default { + pinctrl-single,pins = < + J721S2_IOPAD(0x0ec, PIN_OUTPUT, 6) /* (AG25) TIMER_IO1.USB0_DRVVBUS */ + >; + }; }; &wkup_pmx0 { @@ -318,6 +324,22 @@ serdes0_pcie_link: phy@0 { }; }; +&usb_serdes_mux { + idle-states = <1>; /* USB0 to SERDES lane 1 */ +}; + +&usbss0 { + pinctrl-0 = <&main_usbss0_pins_default>; + pinctrl-names = "default"; + ti,vbus-divider; + ti,usb2-only; +}; + +&usb0 { + dr_mode = "otg"; + maximum-speed = "high-speed"; +}; + &mcu_mcan0 { status = "okay"; pinctrl-names = "default"; -- 2.38.GIT
| |