lkml.org 
[lkml]   [2022]   [Nov]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 14/15] scsi: ufs: ufs-qcom: Add support for finding HS gear on new UFS versions
From
On 31/10/2022 10:56, Manivannan Sadhasivam wrote:
>>> if (hs_gear > UFS_HS_G2)
>>> return UFS_HS_G2;
>>> + } else if (host->hw_ver.major > 0x3) {
>>> + /*
>>> + * Starting from UFS controller v4, Qcom supports dual gear mode (i.e., the
>>> + * controller/PHY can be configured to run in two gear speeds). But that
>>> + * requires an agreement between the UFS controller and the device. Below
>>> + * code tries to find the max gear of both and decides which gear to use.
>>> + *
>>> + * First get the max gear supported by the UFS device if available.
>>> + * If the property is not defined in devicetree, then use the default gear.
>>> + */
>>> + ret = of_property_read_u32(dev->of_node, "max-gear", &max_gear);
>>> + if (ret)
>>> + goto err_out;
>>
>> Can we detect the UFS device's max gear somehow? If not, the 'max-gear'
>> property name doesn't sound good. Maybe calling it 'device-gear' would be
>> better.
>>
>
> UFS device probing depends on PHY init sequence. So technically we cannot know
> the max gear of the device without using an init sequence, but this information
> is static and should be known to a board manufacturer. That's why I decided to
> use this property. Another option is to use a fixed init sequence for probing
> the device and do a re-init after knowing it's max gear but that is not
> recommended.
>

Why it is not recommended? By whom? You init on some default low gear
(support for some is mandated by UFS spec) and then allow faster gears
while you know the capabilities.

> We need "max" keyword because this property specifies the maximum gear at which
> the device could operate and not necessarily the gear at which it operates.
> Maybe, "max-device-gear" would make it clear.


Best regards,
Krzysztof

\
 
 \ /
  Last update: 2022-11-02 21:06    [W:0.141 / U:23.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site