lkml.org 
[lkml]   [2022]   [Nov]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v10 1/2] dt-bindings: mfd: Add MAX5970 and MAX5978
From
On 15/11/2022 21:30, Naresh Solanki wrote:
> Hi Krzysztof,
>
> On 15-11-2022 07:34 pm, Krzysztof Kozlowski wrote:
>> On 15/11/2022 12:09, Naresh Solanki wrote:
>>> From: Marcello Sylvester Bauer <sylv@sylv.io>
>>>
>>> The MAX597x is a hot swap controller with configurable fault protection.
>>> It also has 10bit ADC for current & voltage measurements.
>>>
>>> Signed-off-by: Marcello Sylvester Bauer <sylv@sylv.io>
>>> Co-developed-by: Patrick Rudolph <patrick.rudolph@9elements.com>
>>> Signed-off-by: Patrick Rudolph <patrick.rudolph@9elements.com>
>>> Co-developed-by: Naresh Solanki <Naresh.Solanki@9elements.com>
>>> Signed-off-by: Naresh Solanki <Naresh.Solanki@9elements.com>
>>> ---
>>> .../bindings/mfd/maxim,max5970.yaml | 154 ++++++++++++++++++
>>> 1 file changed, 154 insertions(+)
>>> create mode 100644 Documentation/devicetree/bindings/mfd/maxim,max5970.yaml
>>>
>>> diff --git a/Documentation/devicetree/bindings/mfd/maxim,max5970.yaml b/Documentation/devicetree/bindings/mfd/maxim,max5970.yaml
>>> new file mode 100644
>>> index 000000000000..edf0c23db4ca
>>> --- /dev/null
>>> +++ b/Documentation/devicetree/bindings/mfd/maxim,max5970.yaml
>>> @@ -0,0 +1,154 @@
>>> +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
>>> +%YAML 1.2
>>> +---
>>> +$id: http://devicetree.org/schemas/mfd/maxim,max5970.yaml#
>>> +$schema: http://devicetree.org/meta-schemas/core.yaml#
>>> +
>>> +title: Regulator for MAX5970 smart switch from Maxim Integrated.
>>> +
>>> +maintainers:
>>> + - Patrick Rudolph <patrick.rudolph@9elements.com>
>>> +
>>> +description: |
>>> + The smart switch provides no output regulation, but independent fault protection
>>> + and voltage and current sensing.
>>> + Programming is done through I2C bus.
>>> +
>>> + Datasheets:
>>> + https://datasheets.maximintegrated.com/en/ds/MAX5970.pdf
>>> + https://datasheets.maximintegrated.com/en/ds/MAX5978.pdf
>>> +
>>> +properties:
>>> + compatible:
>>> + enum:
>>> + - maxim,max5970
>>> + - maxim,max5978
>>> +
>>> + reg:
>>> + maxItems: 1
>>> +
>>> + interrupts:
>>> + maxItems: 1
>>> +
>>> + leds:
>>> + type: object
>>> + description:
>>> + Properties for four LEDS.
>>> +
>>> + properties:
>>> + "#address-cells":
>>> + const: 1
>>> +
>>> + "#size-cells":
>>> + const: 0
>>> +
>>> + patternProperties:
>>> + "^led@[0-3]$":
>>> + $ref: /schemas/leds/common.yaml#
>>> + type: object
>>> +
>>> + additionalProperties: false
>>> +
>>> + vss1-supply:
>>> + description: Supply of the first channel.
>>> +
>>> + vss2-supply:
>>> + description: Supply of the second channel.
>>> +
>>> + regulators:
>>> + type: object
>>> + description:
>>> + Properties for both regulators. Also set value for shunt resistor used.
>>
>> You should explain not the syntax, but what part of hardware this nodes
>> represents. Therefore "Also set value" does not fit at all. Hardware
>> sets value?
> You mean something like: Properties for power switch
>>
>> I looked at datasheets to figure it out but they do not refer to any
>> configurable regulator, LDO nor "sw0/sw1/sw2". Therefore I have no clue
>> what to expect here...
> Yes this is for power switch part of max5970/8

Nothing in max5970 datasheet about "power switch". "switch" fives two
results, not really related/explaining.

Bindings, your naming and explanation use terms not existing in
datasheet, so it does not look like you are describing hardware.

>>
>>> +
>>> + patternProperties:
>>> + "^sw[0-1]$":
>>> + $ref: /schemas/regulator/regulator.yaml#
>>> + type: object
>>> + properties:
>>> + shunt-resistor-micro-ohms:
>>> + description: |
>>> + The value of current sense resistor in microohms.
>>> +
>>> + required:
>>> + - shunt-resistor-micro-ohms
>>> +
>>> + unevaluatedProperties: false
>>
>> I don't think it has proper indentation. Did you test the binding?
> Definitely tested the bindings before I push the patch.

Anyway it is wrong. It must be on the level of properties.


Best regards,
Krzysztof

\
 
 \ /
  Last update: 2022-11-16 08:56    [W:2.274 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site