lkml.org 
[lkml]   [2022]   [Nov]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC 0/4] pci/sriov: support VFs dynamic addition
On Fri, Nov 11, 2022 at 10:27:18PM +0800, Longpeng(Mike) wrote:
> From: Longpeng <longpeng2@huawei.com>
>
> We can enable SRIOV and add VFs by /sys/bus/pci/devices/..../sriov_numvfs, but
> this operation needs to spend lots of time if there has a large amount of VFs.
>
> For example, if the machine has 10 PFs and 250 VFs per-PF, enable all the VFs
> concurrently would cost about 200-250ms. However most of them are not need to be
> used at the moment, so we can enable SRIOV first but add VFs on demand.

It is unclear what took 200-250ms, is it physical VF creation or bind of
the driver to these VFs?

If the latter, you can try with sriov_drivers_autoprobe set to true. This is how
ennoblement of large SR-IOV systems is done.

Also PCI spec declares "VF enable" bit, which is applicable to all VFs
associated to that PF, see section "9.3.3.3.1 VF Enable".

Thanks

>
> This series introduces two interfaces:
> 1. sriov_numvfs_no_scan: enable SRIOV without add the VFs.
> 2. sriov_scan_vf_id: add a specific VF.
>
> Longpeng (4):
> pci/sriov: extract sriov_numvfs common helper
> pci/sriov: add vf_bitmap to mark the vf id allocation
> pci/sriov: add sriov_numfs_no_scan interface
> pci/sriov: add sriov_scan_vf_id interface
>
> drivers/pci/iov.c | 162 +++++++++++++++++++++++++++++++++++++++++-----
> drivers/pci/pci.h | 1 +
> 2 files changed, 148 insertions(+), 15 deletions(-)
>
> --
> 2.23.0
>

\
 
 \ /
  Last update: 2022-11-11 17:40    [W:0.198 / U:0.508 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site