lkml.org 
[lkml]   [2022]   [Oct]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] xen/virtio: Handle PCI devices which Host controller is described in DT
On Fri, 7 Oct 2022, Juergen Gross wrote:
> On 06.10.22 19:48, Oleksandr Tyshchenko wrote:
> > From: Oleksandr Tyshchenko <oleksandr_tyshchenko@epam.com>
> >
> > Use the same "xen-grant-dma" device concept (based on generic IOMMU
> > device-tree bindings) for the PCI devices behind device-tree based
> > PCI Host controller.
> >
> > Signed-off-by: Oleksandr Tyshchenko <oleksandr_tyshchenko@epam.com>
> > ---
> > Slightly RFC. This is needed to support Xen grant mappings for virtio-pci
> > devices
> > on Arm at some point in the future. The Xen toolstack side is not published
> > yet.
> > Here, for PCI devices we use the same way to pass backend domid to the guest
> > as for
> > platform devices.
>
> I should mention we decided at the Xen Summit, that I will start a try to
> modify the virtio spec to include the backend id (domid in the Xen case)
> in the device independent config part.

Good idea


> As this will take some time to be accepted (if ever), other means to
> specify the backend domid are needed until then. DT is one possibility
> (at least on Arm), while Xenstore is the way to go for setups with a
> Xen toolstack.

What do you think of my idea of using PCI config registers on the *root
complex* (not the device) to retrieve the information?

\
 
 \ /
  Last update: 2022-10-07 22:26    [W:1.622 / U:0.636 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site