[lkml]   [2022]   [Oct]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH 2/5] dt-bindings: dmaengine: xilinx_dma: Add xlnx,irq-delay property
From: Radhey Shyam Pandey <>

Add an optional AXI DMA property 'xlnx,irq-delay'. It specifies interrupt
timeout value and causes the DMA engine to generate an interrupt after the
delay time period has expired. Timer begins counting at the end of a packet
and resets with receipt of a new packet or a timeout event occurs.

This property is useful when AXI DMA is connected to the streaming IP i.e
axiethernet where inter packet latency is critical while still taking the
benefit of interrupt coalescing.

Signed-off-by: Radhey Shyam Pandey <>
Acked-by: Rob Herring <>
Signed-off-by: Sarath Babu Naidu Gaddam <>
Documentation/devicetree/bindings/dma/xilinx/xilinx_dma.txt | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/dma/xilinx/xilinx_dma.txt b/Documentation/devicetree/bindings/dma/xilinx/xilinx_dma.txt
index 18445aa092ab..9793523633a4 100644
--- a/Documentation/devicetree/bindings/dma/xilinx/xilinx_dma.txt
+++ b/Documentation/devicetree/bindings/dma/xilinx/xilinx_dma.txt
@@ -50,7 +50,9 @@ Optional properties for AXI DMA and MCDMA:
is missing or invalid then the default value 23 is used. This is the
maximum value that is supported by all IP versions.
- xlnx,axistream-connected: Tells whether DMA is connected to AXI stream IP.
+- xlnx,irq-delay: Tells the interrupt delay timeout value. Valid range is from
+ 0-255. Setting this value to zero disables the delay timer interrupt.
+ 1 timeout interval = 125 * clock period of SG clock.
Optional properties for VDMA:
- xlnx,flush-fsync: Tells which channel to Flush on Frame sync.
It takes following values:
 \ /
  Last update: 2022-10-28 07:11    [W:0.097 / U:1.596 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site