lkml.org 
[lkml]   [2022]   [Oct]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v7 09/12] x86/resctrl: Add sysfs interface to write mbm_total_bytes event configuration
From
Hi Reinette,


On 10/25/22 18:48, Reinette Chatre wrote:
> Hi Babu,
>
> On 10/17/2022 3:27 PM, Babu Moger wrote:
>> The current event configuration can be changed by the user by writing
>> to the configuration file /sys/fs/resctrl/info/L3_MON/mbm_total_config.
>> The event configuration settings are domain specific and will affect all
>> the CPUs in the domain.
>>
>> Following are the types of events supported:
>>
>> ==== ===========================================================
>> Bits Description
>> ==== ===========================================================
>> 6 Dirty Victims from the QOS domain to all types of memory
>> 5 Reads to slow memory in the non-local NUMA domain
>> 4 Reads to slow memory in the local NUMA domain
>> 3 Non-temporal writes to non-local NUMA domain
>> 2 Non-temporal writes to local NUMA domain
>> 1 Reads to memory in the non-local NUMA domain
>> 0 Reads to memory in the local NUMA domain
>> ==== ===========================================================
>>
>> For example:
>> To change the mbm_total_bytes to count only reads on domain 0, the bits
>> 0, 1, 4 and 5 needs to be set, which is 110011b (in hex 0x33). Run the
>> command.
>> $echo 0=0x33 > /sys/fs/resctrl/info/L3_MON/mbm_total_config
>>
>> To change the mbm_total_bytes to count all the slow memory reads on
>> domain 1, the bits 4 and 5 needs to be set which is 110000b (in hex 0x30).
>> Run the command.
>> $echo 1=0x30 > /sys/fs/resctrl/info/L3_MON/mbm_total_config
>>
>> Signed-off-by: Babu Moger <babu.moger@amd.com>
>> ---
>> arch/x86/kernel/cpu/resctrl/internal.h | 23 +++++
>> arch/x86/kernel/cpu/resctrl/rdtgroup.c | 146 ++++++++++++++++++++++++++++++++
>> 2 files changed, 169 insertions(+)
>>
>> diff --git a/arch/x86/kernel/cpu/resctrl/internal.h b/arch/x86/kernel/cpu/resctrl/internal.h
>> index 326a1b582f38..c42b12934a0e 100644
>> --- a/arch/x86/kernel/cpu/resctrl/internal.h
>> +++ b/arch/x86/kernel/cpu/resctrl/internal.h
>> @@ -42,6 +42,29 @@
>> */
>> #define MBM_CNTR_WIDTH_OFFSET_MAX (62 - MBM_CNTR_WIDTH_BASE)
>>
>> +/* Reads to Local DRAM Memory */
>> +#define READS_TO_LOCAL_MEM BIT(0)
>> +
>> +/* Reads to Remote DRAM Memory */
>> +#define READS_TO_REMOTE_MEM BIT(1)
>> +
>> +/* Non-Temporal Writes to Local Memory */
>> +#define NON_TEMP_WRITE_TO_LOCAL_MEM BIT(2)
>> +
>> +/* Non-Temporal Writes to Remote Memory */
>> +#define NON_TEMP_WRITE_TO_REMOTE_MEM BIT(3)
>> +
>> +/* Reads to Local Memory the system identifies as "Slow Memory" */
>> +#define READS_TO_LOCAL_S_MEM BIT(4)
>> +
>> +/* Reads to Remote Memory the system identifies as "Slow Memory" */
>> +#define READS_TO_REMOTE_S_MEM BIT(5)
>> +
>> +/* Dirty Victims to All Types of Memory */
>> +#define DIRTY_VICTIMS_TO_ALL_MEM BIT(6)
>> +
>> +/* Max event bits supported */
>> +#define MAX_EVT_CONFIG_BITS GENMASK(6, 0)
>>
>> struct rdt_fs_context {
>> struct kernfs_fs_context kfc;
>> diff --git a/arch/x86/kernel/cpu/resctrl/rdtgroup.c b/arch/x86/kernel/cpu/resctrl/rdtgroup.c
>> index 305fb0475970..25ff56ecb817 100644
>> --- a/arch/x86/kernel/cpu/resctrl/rdtgroup.c
>> +++ b/arch/x86/kernel/cpu/resctrl/rdtgroup.c
>> @@ -1494,6 +1494,151 @@ static int mbm_local_config_show(struct kernfs_open_file *of,
>> return 0;
>> }
>>
>> +static void mon_event_config_write(void *info)
>> +{
>> + struct mon_config_info *mon_info = info;
>> + u32 msr_index;
>> +
>> + switch (mon_info->evtid) {
>> + case QOS_L3_MBM_TOTAL_EVENT_ID:
>> + msr_index = 0;
>> + break;
>> + case QOS_L3_MBM_LOCAL_EVENT_ID:
>> + msr_index = 1;
>> + break;
>> + default:
>> + /* Not expected to come here */
>> + return;
>> + }
>> +
>> + wrmsr(MSR_IA32_EVT_CFG_BASE + msr_index, mon_info->mon_config, 0);
>> +}
> This duplicates most of mon_event_config_read() from earlier patch. Would a
> utility like "mon_event_config_index_get()" help here?
Yes. We can do that.
>
>> +
>> +static int mbm_config_write(struct rdt_resource *r, struct rdt_domain *d,
>> + u32 evtid, u32 val)
>> +{
>> + struct mon_config_info mon_info = {0};
>> + cpumask_var_t cpu_mask;
>> + int ret = 0, cpu;
>> +
>> + rdt_last_cmd_clear();
>> +
>> + /* mon_config cannot be more than the supported set of events */
>> + if (val > MAX_EVT_CONFIG_BITS) {
>> + rdt_last_cmd_puts("Invalid event configuration\n");
>> + return -EINVAL;
>> + }
>> +
>> + cpus_read_lock();
>> +
>> + if (!zalloc_cpumask_var(&cpu_mask, GFP_KERNEL)) {
>> + rdt_last_cmd_puts("cpu_mask allocation failed\n");
>> + ret = -ENOMEM;
>> + goto e_unlock;
>> + }
>> +
>> + /*
>> + * Read the current config value first. If both are same then
>> + * we dont need to write it again.
> "we dont need" -> "we don't need"
Sure.
>
>> + */
>> + mon_info.evtid = evtid;
>> + mondata_config_read(d, &mon_info);
>> + if (mon_info.mon_config == val)
>> + goto e_cpumask;
>> +
>> + mon_info.mon_config = val;
>> +
>> + /* Pick all the CPUs in the domain instance */
>> + for_each_cpu(cpu, &d->cpu_mask)
>> + cpumask_set_cpu(cpu, cpu_mask);
>> +
> Why is it necessary to create a new CPU mask just to populate it
> with all CPUs in another CPU mask? Why not just use the original CPU mask?

I thought convention was to create a new mask when calling on_each_cpu_mask().

But, I dont see that requirement. I can use d->cpu_mask for this directly.

>
>> + /*
>> + * Update MSR_IA32_EVT_CFG_BASE MSRs on all the CPUs in
>> + * cpu_mask. The MSRs offset from MSR MSR_IA32_EVT_CFG_BASE
>> + * are scoped at the domain level. Writing any of these MSRs
>> + * on one CPU is supposed to be observed by all CPUs in the
>> + * domain. However, the hardware team recommends to update
>> + * these MSRs on all the CPUs in the domain.
>> + */
>> + on_each_cpu_mask(cpu_mask, mon_event_config_write, &mon_info, 1);
>> +
>> + /*
>> + * When an Event Configuration is changed, the bandwidth counters
>> + * for all RMIDs and Events will be cleared by the hardware. The
>> + * hardware also sets MSR_IA32_QM_CTR.Unavailable (bit 62) for
>> + * every RMID on the next read to any event for every RMID.
>> + * Subsequent reads will have MSR_IA32_QM_CTR.Unavailable (bit 62)
>> + * cleared while it is tracked by the hardware. Clear the
>> + * mbm_local and mbm_total counts for all the RMIDs.
>> + */
>> + memset(d->mbm_local, 0, sizeof(struct mbm_state) * r->num_rmid);
>> + memset(d->mbm_total, 0, sizeof(struct mbm_state) * r->num_rmid);
>> +
>> +e_cpumask:
>> + free_cpumask_var(cpu_mask);
>> +
>> +e_unlock:
>> + cpus_read_unlock();
>> +
>> + return ret;
>> +}
>> +
>> +static int mon_config_parse(struct rdt_resource *r, char *tok, u32 evtid)
>> +{
>> + char *dom_str = NULL, *id_str;
>> + struct rdt_domain *d;
>> + unsigned long dom_id, val;
> Please use reverse fir tree order.
Sure.
>
>> + int ret = 0;
>> +
>> +next:
>> + if (!tok || tok[0] == '\0')
>> + return 0;
>> +
>> + /* Start processing the strings for each domain */
>> + dom_str = strim(strsep(&tok, ";"));
>> + id_str = strsep(&dom_str, "=");
>> +
>> + if (!dom_str || kstrtoul(id_str, 10, &dom_id)) {
>> + rdt_last_cmd_puts("Missing '=' or non-numeric domain id\n");
>> + return -EINVAL;
>> + }
>> +
>> + if (!dom_str || kstrtoul(dom_str, 16, &val)) {
>> + rdt_last_cmd_puts("Missing '=' or non-numeric event configuration value\n");
>> + return -EINVAL;
>> + }
>> +
>> + list_for_each_entry(d, &r->domains, list) {
>> + if (d->id == dom_id) {
>> + ret = mbm_config_write(r, d, evtid, val);
>> + if (ret)
>> + return -EINVAL;
>> + goto next;
>> + }
>> + }
>> +
>> + return -EINVAL;
>> +}
>> +
>> +static ssize_t mbm_total_config_write(struct kernfs_open_file *of,
>> + char *buf, size_t nbytes, loff_t off)
>> +{
>> + struct rdt_resource *r = of->kn->parent->priv;
>> + int ret;
>> +
>> + /* Valid input requires a trailing newline */
>> + if (nbytes == 0 || buf[nbytes - 1] != '\n')
>> + return -EINVAL;
>> +
>> + rdt_last_cmd_clear();
>> +
> How is this code protected from interference by other actions? Needs rdtgroup_mutex?

Yes. Sure.

Thanks

Babu

>
>> + buf[nbytes - 1] = '\0';
>> +
>> + ret = mon_config_parse(r, buf, QOS_L3_MBM_TOTAL_EVENT_ID);
>> +
>> + return ret ?: nbytes;
>> +}
>> +
>> /* rdtgroup information files for one cache resource. */
>> static struct rftype res_common_files[] = {
>> {
>> @@ -1597,6 +1742,7 @@ static struct rftype res_common_files[] = {
>> .mode = 0644,
>> .kf_ops = &rdtgroup_kf_single_ops,
>> .seq_show = mbm_total_config_show,
>> + .write = mbm_total_config_write,
>> },
>> {
>> .name = "mbm_local_config",
>>
>>
> Reinette

--
Thanks
Babu Moger

\
 
 \ /
  Last update: 2022-10-26 21:54    [W:2.001 / U:0.560 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site