lkml.org 
[lkml]   [2022]   [Oct]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v3 4/7] mms: sdhci-esdhc-imx: Fix SDHCI_RESET_ALL for CQHCI
From
On 24/10/22 20:54, Brian Norris wrote:
> [[ NOTE: this is completely untested by the author, but included solely
> because, as noted in commit df57d73276b8 ("mmc: sdhci-pci: Fix
> SDHCI_RESET_ALL for CQHCI for Intel GLK-based controllers"), "other
> drivers using CQHCI might benefit from a similar change, if they
> also have CQHCI reset by SDHCI_RESET_ALL." We've now seen the same
> bug on at least MSM, Arasan, and Intel hardware. ]]
>
> SDHCI_RESET_ALL resets will reset the hardware CQE state, but we aren't
> tracking that properly in software. When out of sync, we may trigger
> various timeouts.
>
> It's not typical to perform resets while CQE is enabled, but this may
> occur in some suspend or error recovery scenarios.
>
> Include this fix by way of the new sdhci_and_cqhci_reset() helper.
>
> Fixes: bb6e358169bf ("mmc: sdhci-esdhc-imx: add CMDQ support")
> Signed-off-by: Brian Norris <briannorris@chromium.org>
> Reviewed-by: Haibo Chen <haibo.chen@nxp.com>

This patch is dependent on "mmc: cqhci: Provide
helper for resetting both SDHCI and CQHCI". Best point that out
in this commit message as well.

Otherwise:

Acked-by: Adrian Hunter <adrian.hunter@intel.com>

> ---
>
> Changes in v3:
> - Use new SDHCI+CQHCI helper
> - Add Reviewed-by
>
> Changes in v2:
> - Drop unnecessary ESDHC_FLAG_CQHCI check
>
> drivers/mmc/host/sdhci-esdhc-imx.c | 3 ++-
> 1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
> index 55981b0f0b10..b297c3c360eb 100644
> --- a/drivers/mmc/host/sdhci-esdhc-imx.c
> +++ b/drivers/mmc/host/sdhci-esdhc-imx.c
> @@ -25,6 +25,7 @@
> #include <linux/of_device.h>
> #include <linux/pinctrl/consumer.h>
> #include <linux/pm_runtime.h>
> +#include "sdhci-cqhci.h"
> #include "sdhci-pltfm.h"
> #include "sdhci-esdhc.h"
> #include "cqhci.h"
> @@ -1288,7 +1289,7 @@ static void esdhc_set_uhs_signaling(struct sdhci_host *host, unsigned timing)
>
> static void esdhc_reset(struct sdhci_host *host, u8 mask)
> {
> - sdhci_reset(host, mask);
> + sdhci_and_cqhci_reset(host, mask);
>
> sdhci_writel(host, host->ier, SDHCI_INT_ENABLE);
> sdhci_writel(host, host->ier, SDHCI_SIGNAL_ENABLE);

\
 
 \ /
  Last update: 2022-10-25 15:11    [W:0.119 / U:1.472 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site