lkml.org 
[lkml]   [2022]   [Oct]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 4/7] mms: sdhci-esdhc-imx: Fix SDHCI_RESET_ALL for CQHCI
Date
 [[ NOTE: this is completely untested by the author, but included solely
because, as noted in commit df57d73276b8 ("mmc: sdhci-pci: Fix
SDHCI_RESET_ALL for CQHCI for Intel GLK-based controllers"), "other
drivers using CQHCI might benefit from a similar change, if they
also have CQHCI reset by SDHCI_RESET_ALL." We've now seen the same
bug on at least MSM, Arasan, and Intel hardware. ]]

SDHCI_RESET_ALL resets will reset the hardware CQE state, but we aren't
tracking that properly in software. When out of sync, we may trigger
various timeouts.

It's not typical to perform resets while CQE is enabled, but this may
occur in some suspend or error recovery scenarios.

Include this fix by way of the new sdhci_and_cqhci_reset() helper.

Fixes: bb6e358169bf ("mmc: sdhci-esdhc-imx: add CMDQ support")
Signed-off-by: Brian Norris <briannorris@chromium.org>
Reviewed-by: Haibo Chen <haibo.chen@nxp.com>
---

Changes in v3:
- Use new SDHCI+CQHCI helper
- Add Reviewed-by

Changes in v2:
- Drop unnecessary ESDHC_FLAG_CQHCI check

drivers/mmc/host/sdhci-esdhc-imx.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
index 55981b0f0b10..b297c3c360eb 100644
--- a/drivers/mmc/host/sdhci-esdhc-imx.c
+++ b/drivers/mmc/host/sdhci-esdhc-imx.c
@@ -25,6 +25,7 @@
#include <linux/of_device.h>
#include <linux/pinctrl/consumer.h>
#include <linux/pm_runtime.h>
+#include "sdhci-cqhci.h"
#include "sdhci-pltfm.h"
#include "sdhci-esdhc.h"
#include "cqhci.h"
@@ -1288,7 +1289,7 @@ static void esdhc_set_uhs_signaling(struct sdhci_host *host, unsigned timing)

static void esdhc_reset(struct sdhci_host *host, u8 mask)
{
- sdhci_reset(host, mask);
+ sdhci_and_cqhci_reset(host, mask);

sdhci_writel(host, host->ier, SDHCI_INT_ENABLE);
sdhci_writel(host, host->ier, SDHCI_SIGNAL_ENABLE);
--
2.38.0.135.g90850a2211-goog
\
 
 \ /
  Last update: 2022-10-24 21:23    [W:0.211 / U:0.364 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site