lkml.org 
[lkml]   [2022]   [Oct]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v12,2/3] drm: mediatek: Set dpi format in mmsys
On Fri, Oct 21, 2022 at 08:18:25PM +0800, xinlei.lee wrote:
> On Thu, 2022-10-20 at 12:40 -0400, Nícolas F. R. A. Prado wrote:
> > On Wed, Oct 19, 2022 at 10:52:15AM +0800, xinlei.lee@mediatek.com
> > wrote:
[..]
> > > @@ -448,8 +453,12 @@ static void mtk_dpi_dual_edge(struct mtk_dpi
> > > *dpi)
> > > mtk_dpi_mask(dpi, DPI_OUTPUT_SETTING,
> > > dpi->output_fmt ==
> > > MEDIA_BUS_FMT_RGB888_2X12_LE ?
> > > EDGE_SEL : 0, EDGE_SEL);
> > > + if (dpi->conf->edge_cfg_in_mmsys)
> > > + mtk_mmsys_ddp_dpi_fmt_config(dpi->mmsys_dev,
> > > MTK_DPI_RGB888_DDR_CON);
> > > } else {
> > > mtk_dpi_mask(dpi, DPI_DDR_SETTING, DDR_EN | DDR_4PHASE,
> > > 0);
> > > + if (dpi->conf->edge_cfg_in_mmsys)
> > > + mtk_mmsys_ddp_dpi_fmt_config(dpi->mmsys_dev,
> > > MTK_DPI_RGB888_SDR_CON);
> >
> > I know this isn't one of the formats supported by MT8186, but since
> > we're using
> > platform-agnostic formats now... This else branch in theory could
> > also run for a
> > format like MEDIA_BUS_FMT_YUYV8_1X16. Would it make sense to set
> > MTK_DPI_RGB888_SDR_CON in that case?
> >
> > Thanks,
> > Nícolas
> >
> > > }
> >
> > [..]
>
> Hi Nícolas:
>
> Thanks for your review!
>
> You are right, I understand you think this MTK_DPI_RGB888_SDR_CON
> format seems useless as it will not be set, I confirmed with the
> designer how the setting in mmsys affects the output format of the
> MT8186, this mmsys setting will not be used by other ICs.
>
> As mentioned earlier, the mmsys setting will make the MT8186dpi have
> four output formats, even though the MT8186 dpi may not use them all.
>
> So what needs to change here?

We could check that the format in the else path is a single edge RGB888 format
like MEDIA_BUS_FMT_RGB888_1X24 before setting the mmsys config, but there are
also other formats possible, and I actually don't think it's worth it to
complicate the logic further to protect from an edge-case that can't be hit
yet...

So just leave it as it is. We can worry about it when/if a non-RGB888 single
edge format needs to be setup on mmsys.

So,

Reviewed-by: Nícolas F. R. A. Prado <nfraprado@collabora.com>

Thanks,
Nícolas

\
 
 \ /
  Last update: 2022-10-21 17:48    [W:0.058 / U:1.324 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site