Messages in this thread Patch in this message | | | From | Cristian Marussi <> | Subject | [PATCH v4 06/11] firmware: arm_scmi: Add xfer raw helpers | Date | Wed, 19 Oct 2022 21:46:21 +0100 |
| |
Add a few SCMI helpers useful to implement SCMI Raw access support.
Signed-off-by: Cristian Marussi <cristian.marussi@arm.com> --- v3 --> v4 - add scmi_xfer_raw_wait_for_response helper - fixed typos in comments v2 --> v3 - allow for DT-unknown protocols to get a channel v1 --> v2 - added scmi_xfer_raw_channel_get --- drivers/firmware/arm_scmi/common.h | 12 +++ drivers/firmware/arm_scmi/driver.c | 141 +++++++++++++++++++++++++++++ 2 files changed, 153 insertions(+)
diff --git a/drivers/firmware/arm_scmi/common.h b/drivers/firmware/arm_scmi/common.h index 30d056febef1..3dceb69b8484 100644 --- a/drivers/firmware/arm_scmi/common.h +++ b/drivers/firmware/arm_scmi/common.h @@ -230,6 +230,18 @@ static inline bool is_polling_enabled(struct scmi_chan_info *cinfo, is_transport_polling_capable(desc); } +void scmi_xfer_raw_put(const struct scmi_handle *handle, + struct scmi_xfer *xfer); +struct scmi_xfer *scmi_xfer_raw_get(const struct scmi_handle *handle); +struct scmi_chan_info * +scmi_xfer_raw_channel_get(const struct scmi_handle *handle, u8 protocol_id); + +int scmi_xfer_raw_inflight_register(const struct scmi_handle *handle, + struct scmi_xfer *xfer); + +int scmi_xfer_raw_wait_for_message_response(struct scmi_chan_info *cinfo, + struct scmi_xfer *xfer, + unsigned int timeout_ms); #ifdef CONFIG_ARM_SCMI_TRANSPORT_MAILBOX extern const struct scmi_desc scmi_mailbox_desc; #endif diff --git a/drivers/firmware/arm_scmi/driver.c b/drivers/firmware/arm_scmi/driver.c index d496dfe43618..3649435082bb 100644 --- a/drivers/firmware/arm_scmi/driver.c +++ b/drivers/firmware/arm_scmi/driver.c @@ -350,6 +350,53 @@ scmi_xfer_inflight_register_unlocked(struct scmi_xfer *xfer, xfer->pending = true; } +/** + * scmi_xfer_inflight_register - Try to register an xfer as in-flight + * + * @xfer: The xfer to register + * @minfo: Pointer to Tx/Rx Message management info based on channel type + * + * Note that this helper does NOT assume anything about the sequence number + * that was baked into the provided xfer, so it checks at first if it can + * be mapped to a free slot and fails with an error if another xfer with the + * same sequence number is currently still registered as in-flight. + * + * Return: 0 on Success or -EBUSY if sequence number embedded in the xfer + * could not rbe mapped to a free slot in the xfer_alloc_table. + */ +static int scmi_xfer_inflight_register(struct scmi_xfer *xfer, + struct scmi_xfers_info *minfo) +{ + int ret = 0; + unsigned long flags; + + spin_lock_irqsave(&minfo->xfer_lock, flags); + if (!test_bit(xfer->hdr.seq, minfo->xfer_alloc_table)) + scmi_xfer_inflight_register_unlocked(xfer, minfo); + else + ret = -EBUSY; + spin_unlock_irqrestore(&minfo->xfer_lock, flags); + + return ret; +} + +/** + * scmi_xfer_raw_inflight_register - An helper to register the given xfer as in + * flight on the TX channel, if possible. + * + * @handle: Pointer to SCMI entity handle + * @xfer: The xfer to register + * + * Return: 0 on Success, error otherwise + */ +int scmi_xfer_raw_inflight_register(const struct scmi_handle *handle, + struct scmi_xfer *xfer) +{ + struct scmi_info *info = handle_to_scmi_info(handle); + + return scmi_xfer_inflight_register(xfer, &info->tx_minfo); +} + /** * scmi_xfer_pending_set - Pick a proper sequence number and mark the xfer * as pending in-flight @@ -425,6 +472,58 @@ static struct scmi_xfer *scmi_xfer_get(const struct scmi_handle *handle, return xfer; } +/** + * scmi_xfer_raw_get - Helper to get a bare free xfer from the TX channel + * + * @handle: Pointer to SCMI entity handle + * + * Note that xfer is taken from the TX channel structures. + * + * Return: A valid xfer on Success, or an error-pointer otherwise + */ +struct scmi_xfer *scmi_xfer_raw_get(const struct scmi_handle *handle) +{ + struct scmi_info *info = handle_to_scmi_info(handle); + + return scmi_xfer_get(handle, &info->tx_minfo); +} + +/** + * scmi_xfer_raw_channel_get - Helper to get a reference to the proper channel + * to use for a specific protocol_id Raw transaction. + * + * @handle: Pointer to SCMI entity handle + * @protocol_id: Identifier of the protocol + * + * Note that in a regular SCMI stack, usually, a protocol has to be defined in + * the DT to have an associated channel and be usable; but in Raw mode any + * protocol in range is allowed, re-using the Base channel, so as to enable + * fuzzing on any protocol without the need of a fully compiled DT. + * + * Return: A reference to the channel to use, or an ERR_PTR + */ +struct scmi_chan_info * +scmi_xfer_raw_channel_get(const struct scmi_handle *handle, u8 protocol_id) +{ + struct scmi_chan_info *cinfo; + struct scmi_info *info = handle_to_scmi_info(handle); + + cinfo = idr_find(&info->tx_idr, protocol_id); + if (!cinfo) { + if (protocol_id == SCMI_PROTOCOL_BASE) + return ERR_PTR(-EINVAL); + /* Use Base channel for protocols not defined for DT */ + cinfo = idr_find(&info->tx_idr, SCMI_PROTOCOL_BASE); + if (!cinfo) + return ERR_PTR(-EINVAL); + dev_warn_once(handle->dev, + "Using Base channel for protocol 0x%X\n", + protocol_id); + } + + return cinfo; +} + /** * __scmi_xfer_put() - Release a message * @@ -453,6 +552,22 @@ __scmi_xfer_put(struct scmi_xfers_info *minfo, struct scmi_xfer *xfer) spin_unlock_irqrestore(&minfo->xfer_lock, flags); } +/** + * scmi_xfer_raw_put - Release an xfer that was taken by @scmi_xfer_raw_get + * + * @handle: Pointer to SCMI entity handle + * @xfer: A reference to the xfer to put + * + * Note that as with other xfer_put() handlers the xfer is really effectively + * released only if there are no more users on the system. + */ +void scmi_xfer_raw_put(const struct scmi_handle *handle, struct scmi_xfer *xfer) +{ + struct scmi_info *info = handle_to_scmi_info(handle); + + return __scmi_xfer_put(&info->tx_minfo, xfer); +} + /** * scmi_xfer_lookup_unlocked - Helper to lookup an xfer_id * @@ -879,6 +994,32 @@ static int scmi_wait_for_message_response(struct scmi_chan_info *cinfo, info->desc->max_rx_timeout_ms); } +/** + * scmi_xfer_raw_wait_for_message_response - An helper to wait for a message + * reply to an xfer raw request on a specific channel for the required timeout. + * + * @cinfo: SCMI channel info + * @xfer: Reference to the transfer being waited for. + * @timeout_ms: The maximum timeout in milliseconds + * + * Return: 0 on Success, error otherwise. + */ +int scmi_xfer_raw_wait_for_message_response(struct scmi_chan_info *cinfo, + struct scmi_xfer *xfer, + unsigned int timeout_ms) +{ + int ret; + struct scmi_info *info = handle_to_scmi_info(cinfo->handle); + struct device *dev = info->dev; + + ret = scmi_wait_for_reply(dev, info->desc, cinfo, xfer, timeout_ms); + if (ret) + dev_dbg(dev, "timed out in RAW response - HDR:%08X\n", + pack_scmi_header(&xfer->hdr)); + + return ret; +} + /** * do_xfer() - Do one transfer * -- 2.34.1
| |