lkml.org 
[lkml]   [2022]   [Oct]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/1] usb: cdns3: host: fix endless superspeed hub port reset
Date
From: Li Jun <jun.li@nxp.com>

When usb 3.0 hub connect with one USB 2.0 device and NO USB 3.0 device,
some usb hub reports endless port reset message.

[ 190.324169] usb 2-1: new SuperSpeed USB device number 88 using xhci-hcd
[ 190.352834] hub 2-1:1.0: USB hub found
[ 190.356995] hub 2-1:1.0: 4 ports detected
[ 190.700056] usb 2-1: USB disconnect, device number 88
[ 192.472139] usb 2-1: new SuperSpeed USB device number 89 using xhci-hcd
[ 192.500820] hub 2-1:1.0: USB hub found
[ 192.504977] hub 2-1:1.0: 4 ports detected
[ 192.852066] usb 2-1: USB disconnect, device number 89

The reason is the runtime pm state of USB2.0 port is active and
USB 3.0 port is suspend, so parent device is active state.

cat /sys/bus/platform/devices/5b110000.usb/5b130000.usb/xhci-hcd.1.auto/usb2/power/runtime_status

suspended

cat /sys/bus/platform/devices/5b110000.usb/5b130000.usb/xhci-hcd.1.auto/usb1/power/runtime_status

active

cat /sys/bus/platform/devices/5b110000.usb/5b130000.usb/xhci-hcd.1.auto/power/runtime_status

active

cat /sys/bus/platform/devices/5b110000.usb/5b130000.usb/power/runtime_status

active

So xhci_cdns3_suspend_quirk() have not called. U3 configure is not applied.

move U3 configure into host start

Signed-off-by: Li Jun <jun.li@nxp.com>
Signed-off-by: Frank Li <Frank.Li@nxp.com>
---
drivers/usb/cdns3/host.c | 58 +++++++++++++++++++++-------------------
1 file changed, 31 insertions(+), 27 deletions(-)

diff --git a/drivers/usb/cdns3/host.c b/drivers/usb/cdns3/host.c
index 9643b905e2d8..9092b6f4d7c4 100644
--- a/drivers/usb/cdns3/host.c
+++ b/drivers/usb/cdns3/host.c
@@ -24,11 +24,41 @@
#define CFG_RXDET_P3_EN BIT(15)
#define LPM_2_STB_SWITCH_EN BIT(25)

-static int xhci_cdns3_suspend_quirk(struct usb_hcd *hcd);
+static void xhci_cdns3_plat_start(struct usb_hcd *hcd)
+{
+ struct xhci_hcd *xhci = hcd_to_xhci(hcd);
+ u32 value;
+
+ /* set usbcmd.EU3S */
+ value = readl(&xhci->op_regs->command);
+ value |= CMD_PM_INDEX;
+ writel(value, &xhci->op_regs->command);
+
+ if (hcd->regs) {
+ value = readl(hcd->regs + XECP_AUX_CTRL_REG1);
+ value |= CFG_RXDET_P3_EN;
+ writel(value, hcd->regs + XECP_AUX_CTRL_REG1);
+
+ value = readl(hcd->regs + XECP_PORT_CAP_REG);
+ value |= LPM_2_STB_SWITCH_EN;
+ writel(value, hcd->regs + XECP_PORT_CAP_REG);
+ }
+}
+
+static int xhci_cdns3_suspend_quirk(struct usb_hcd *hcd)
+{
+ if (pm_runtime_status_suspended(hcd->self.controller))
+ return 0;
+
+ xhci_cdns3_plat_start(hcd);
+
+ return 0;
+}

static const struct xhci_plat_priv xhci_plat_cdns3_xhci = {
.quirks = XHCI_SKIP_PHY_INIT | XHCI_AVOID_BEI,
.suspend_quirk = xhci_cdns3_suspend_quirk,
+ .plat_start = xhci_cdns3_plat_start,
};

static int __cdns_host_init(struct cdns *cdns)
@@ -90,32 +120,6 @@ static int __cdns_host_init(struct cdns *cdns)
return ret;
}

-static int xhci_cdns3_suspend_quirk(struct usb_hcd *hcd)
-{
- struct xhci_hcd *xhci = hcd_to_xhci(hcd);
- u32 value;
-
- if (pm_runtime_status_suspended(hcd->self.controller))
- return 0;
-
- /* set usbcmd.EU3S */
- value = readl(&xhci->op_regs->command);
- value |= CMD_PM_INDEX;
- writel(value, &xhci->op_regs->command);
-
- if (hcd->regs) {
- value = readl(hcd->regs + XECP_AUX_CTRL_REG1);
- value |= CFG_RXDET_P3_EN;
- writel(value, hcd->regs + XECP_AUX_CTRL_REG1);
-
- value = readl(hcd->regs + XECP_PORT_CAP_REG);
- value |= LPM_2_STB_SWITCH_EN;
- writel(value, hcd->regs + XECP_PORT_CAP_REG);
- }
-
- return 0;
-}
-
static void cdns_host_exit(struct cdns *cdns)
{
kfree(cdns->xhci_plat_data);
--
2.34.1
\
 
 \ /
  Last update: 2022-10-19 17:32    [W:2.270 / U:0.488 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site