lkml.org 
[lkml]   [2022]   [Oct]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 00/10] Add support for USB on STM32MP13
From
On 10/14/22 11:26, Fabrice Gasnier wrote:
> Add support for USBPHYC, USB Host and USB OTG on STM32MP13.
> Enable all these interfaces on STM32MP135F-DK board.
> Enable the STM32G0 UCSI driver as module.
> Dependency on PWR and PMIC regulator is tempoarily managed by using
> fixed regulators (resp in the SoC dtsi and the board dts files).
> The USB support is functional when these regulators gets enabled at
> boot time before entering the kernel.

Hi,

Please discard this series. Generic node names recommendation has been
missed.
I'll send a V2.

Sorry for the noise.
Best Regards,
Fabrice

>
> Amelie Delaunay (5):
> ARM: dts: stm32: add USBPHYC and dual USB HS PHY support on stm32mp131
> ARM: dts: stm32: add UBSH EHCI and OHCI support on stm32mp131
> ARM: dts: stm32: add USB OTG HS support on stm32mp131
> ARM: dts: stm32: enable USB HS phys on stm32mp135f-dk
> ARM: dts: stm32: enable USB Host EHCI on stm32mp135f-dk
>
> Fabrice Gasnier (5):
> ARM: dts: stm32: add PWR fixed regulators on stm32mp131
> ARM: dts: stm32: add fixed regulators to support usb on stm32mp135f-dk
> ARM: dts: stm32: add pins for stm32g0 typec controller on stm32mp13
> ARM: dts: stm32: enable USB OTG in dual role mode on stm32mp135f-dk
> ARM: multi_v7_defconfig: enable Type-C UCSI and STM32G0 as modules
>
> arch/arm/boot/dts/stm32mp13-pinctrl.dtsi | 7 ++
> arch/arm/boot/dts/stm32mp131.dtsi | 81 ++++++++++++++++++++
> arch/arm/boot/dts/stm32mp135f-dk.dts | 95 ++++++++++++++++++++++++
> arch/arm/configs/multi_v7_defconfig | 2 +
> 4 files changed, 185 insertions(+)
>

\
 
 \ /
  Last update: 2022-10-14 16:05    [W:0.069 / U:0.416 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site