lkml.org 
[lkml]   [2022]   [Oct]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 00/10] Add support for USB on STM32MP13
Date
Add support for USBPHYC, USB Host and USB OTG on STM32MP13.
Enable all these interfaces on STM32MP135F-DK board.
Enable the STM32G0 UCSI driver as module.
Dependency on PWR and PMIC regulator is tempoarily managed by using
fixed regulators (resp in the SoC dtsi and the board dts files).
The USB support is functional when these regulators gets enabled at
boot time before entering the kernel.

Amelie Delaunay (5):
ARM: dts: stm32: add USBPHYC and dual USB HS PHY support on stm32mp131
ARM: dts: stm32: add UBSH EHCI and OHCI support on stm32mp131
ARM: dts: stm32: add USB OTG HS support on stm32mp131
ARM: dts: stm32: enable USB HS phys on stm32mp135f-dk
ARM: dts: stm32: enable USB Host EHCI on stm32mp135f-dk

Fabrice Gasnier (5):
ARM: dts: stm32: add PWR fixed regulators on stm32mp131
ARM: dts: stm32: add fixed regulators to support usb on stm32mp135f-dk
ARM: dts: stm32: add pins for stm32g0 typec controller on stm32mp13
ARM: dts: stm32: enable USB OTG in dual role mode on stm32mp135f-dk
ARM: multi_v7_defconfig: enable Type-C UCSI and STM32G0 as modules

arch/arm/boot/dts/stm32mp13-pinctrl.dtsi | 7 ++
arch/arm/boot/dts/stm32mp131.dtsi | 81 ++++++++++++++++++++
arch/arm/boot/dts/stm32mp135f-dk.dts | 95 ++++++++++++++++++++++++
arch/arm/configs/multi_v7_defconfig | 2 +
4 files changed, 185 insertions(+)

--
2.25.1

\
 
 \ /
  Last update: 2022-10-14 10:34    [W:0.030 / U:0.212 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site